Replaces

1999-10 Ford Crown Victoria Tail Light Pair - 1ALTP00632

These replacement tail lights are just what you need to get your vehicle in good looking form again!

These tail lights feature the following specifications:

  • Includes Both LH (Driver's Side) & RH (Passenger's Side)
  • All RED LENSES with CHROME MOULDINGS
    • Have TWO bulb sockets in the housings
  • Replaces dealer part numbers: XW7Z 13405 BA, XW7Z13405BA, XW7Z 13404 BA, XW7Z13404BA
  • Includes lenses & housings
  • DOT (Department of Transportation) & SAE (Society of Automotive Engineers) approved
  • Direct replacements
  • Do not have provisions for Police strobes
    • Tail light housings would have to be modified for Police use

These tail lights make great replacements and have substantial cost savings over the dealer units.

Direct Fit Replacement

Direct fit replacement for OEM assembly

Trouble-free Installation

Uses same wiring as original assembly.  No cutting or splicing required.

DOT and SAE Compliant

Meets federal regulations for on-road use

Part Details

  • Light Option: 2 Bulb Socket
  • Quantity: Pair
  • Color: Red
  • Light Option: Chrome Trim

Lifetime Warranty

This item is backed by a Limited Lifetime Warranty. In the event this item should fail due to manufacturing defects during intended use, we will exchange the part free of charge (excludes shipping charges) for the original purchaser.

  1. step : Removing the Taillight Assembly (0:55)
    • Twist off the plastic clip behind the taillight.
    • Pull the side insulation panel off.
    • Pull the insulation panel behind the taillight back.
    • Remove the three 11mm nuts on the back of the taillight.
    • Pull the taillight forward.
  2. step : Replacing a Bulb (2:02)
    • Twist out the socket.
    • Pull the bulbs straight out.
    • Push the new bulb into place.
    • Twist the socket back into place.
  3. step : Replacing the Taillight Assembly (2:30)
    • Twist the sockets into the new taillight assembly.
    • Line up the taillight and push it into place.
    • Replace the three 11mm nuts.
    • Put the insulation panel back into place.
    • Twist the plastic clip back into place.

Tools needed for replacement:

    Ratchets & Related

  • Ratchet

  • Sockets - Metric

  • 11mm Socket

There are no reviews for this item. Write Review
Start typing your question and we'll check if it was already asked and answered. Learn More
No questions have been asked about this item. Be the first!

Vehicle Fit

  • 1999-2010 Ford Crown Victoria 2 Bulb Socket Red Tail Light with Chrome Trim Pair

This part replaces:

  • OE # XW7Z 13404 BA
  • OE # XW7Z 13405 BA
  • Partslink FO2801176, FO2800176
Only 1 left in stock
Part #: 1ALTP00632

How-to Video:

(03:56 min)