1999-03 Jeep Grand Cherokee Passenger Side Tinted Lens Fog / Driving Light

This replacement fog driving light is just what you need to get your vehicle in good looking form again!

Specifications:

• Fits RH (Passenger Side)
  • Mounts in the bumper
• Replaces dealer part number: 55155136AC
• Tinted (Smoked) Lens
• Injection molded plastic
• DOT (Department of Transportation) & SAE (Society of Automotive Engineers) approved
• Direct replacement fog light
• Fog light does not include bulbs or wiring

This fog driving lamp is a great replacement and has good cost savings over a fog light from the dealer.

Bulb Note:

Unless otherwise noted, our lights do not include bulbs, though occasionally lighting manufacturers do include bulbs in the lights. If you happen to receive a lighting product (Headlight, Tail light, parking light, fog light etc.) that comes with the bulbs, the bulbs are not covered under our warranty. Our warranty applies only to the light assembly.

Direct fit replacement for OEM assembly

Uses same wiring as original assembly.  No cutting or splicing required.

Meets federal regulations for on-road use

Item Condition: New

Attention California Customers:

WARNING:  This product can expose you to chemicals including Chromium (Hexavalent Compounds), which is known to the State of California to cause cancer, and birth defects or other reproductive harm.  For more information, go to www.P65Warnings.ca.gov.

Lifetime Warranty

This item is backed by our limited lifetime warranty. In the event this item should fail due to manufacturing defects during intended use, we will replace the part free of charge.

step : Remove the fog lights (1:45)

• Under the vehicle, there are two 10 mm bolts.
• Hit them with penetrating oil and give it a few minutes to work its magic, especially if it’s a rust belt car.
• Remove the bolts with your wrench or 10 mm socket and ratchet.
• Unplug the wiring harness.
• Change the bulbs or swap the bulbs into a new assembly.

step : Install the new fog light (3:44)

• Remove the old studs with a pair of vise grip pliers and a wrench.
• Use the vise grip again to take the nut from the old bolt to use on the new one.
• Plug in the wiring harness and bolt the new fog light assembly in.
• Use your 10 mm socket and ratchet.