1998-01 Acura Integra Steering & Suspension Kit 10 Piece Set - 1ASFK01863

Our steering and suspension components come pre-greased, sealed for long life, and do not require the extra maintenance typically required by greasable versions.

Application-specific, with no modifications required.

Made from higher quality materials than the competition. Built to have a longer life in any environment or road conditions.

By the same factories that the OEMs use.

Carefully assembled to include all of the parts you need, saving time and money.

Item Condition: New

Attention California Customers:

WARNING:  This product can expose you to chemicals including Chromium (Hexavalent Compounds), which is known to the State of California to cause cancer, and birth defects or other reproductive harm.  For more information, go to www.P65Warnings.ca.gov.

Lifetime Warranty

This item is backed by our limited lifetime warranty. In the event this item should fail due to manufacturing defects during intended use, we will replace the part free of charge.

Note: When replacing steering components, it is recommended to have a professional alignment performed on the vehicle afterwards. This will ensure proper tracking and even tire wear.

step : Removing the Wheel (0:40)

• Loosen the lug nut covers
• Pry off the center cap with a flat blade screwdriver
• Loosen the lug nuts with the vehicle on the ground
• Raise the vehicle with a floor jack
• Secure the vehicle on jack stands
• Remove the lug nuts
• Pull off the wheel

step : Removing the Tie Rod (1:00)

• Measure from the boot to the outer tie rod and record it
• Loosen the 19mm nut on the tie rod with a 19mm wrench
• Remove the cotter pin with pliers
• Remove the castle nut with a 17mm socket
• Hit the knuckle with a hammer
• Twist the tie rod out

step : Installing the New Tie Rod (2:13)

• Twist on the new tie rod
• Push the outer tie rod down into the knuckle
• Replace the castle nut
• Push the cotter pin into place and bend the ends in separate directions with pliers
• Measure and double check the distance of the boot to the tie rod
• Turn the tie rod joint with the 14mm wrench to adjust the distance
• Replace and tighten the 19mm nut

step : Reattaching the Wheel (3:15)

• Slide the wheel into place
• Start the lug nuts by hand
• Tighten the lug nuts preliminarily
• Lower the vehicle to the ground
• Tighten the lug nuts to between 100 foot-pounds in a crossing or star pattern
• Reattach the center cap