Replaces
This part doesn’t fit a . Select from parts that fit.
1A Auto Lifetime Warranty
Frequently bought together
Left Hand Drive:
All of our auto parts are intended for Left Hand Drive USDM vehicles. If your vehicle is Right Hand Drive, please ensure the part is correct for your specific vehicle.
Item Condition:
New
Attention California Customers:
WARNING: This product can expose you to chemicals including Di(2-ethylhexyl)phthalate (DEHP), which is known to the State of California to cause cancer, and birth defects or other reproductive harm. For more information, go to www.P65Warnings.ca.gov.
Lifetime Warranty
This item is backed by our limited lifetime warranty. In the event that this item should fail due to manufacturing defects during intended use, we will replace the part free of charge. This warranty covers the cost of the part only.
Returns: Parts with electrical components cannot be returned once installed.
FREE Shipping is standard on Orders shipped to the lower 48 States (Contiguous United States). Standard shipping charges apply to Hawaii, Alaska and US Territories. Shipping is not available to Canada.
Expedited is available on checkout to the United States, excluding Alaska, Hawaii and US Territories as well as P.O. Boxes and APO/FPO/DPO addresses. Final shipping costs are available at checkout.
Created on:
Tools used
Brought to you by 1AAuto.com, your source for quality replacement parts and the best service on the Internet.
Hi, I'm Mike from 1A Auto. I hope this how-to video helps you out, and next time you need parts for your vehicle, think of 1AAuto.com. Thanks.
In this video we're going to show you how to replace the AC and heater fan blower motor in this '99 Toyota 4Runner, same as any '96 to 2002 4Runner. Tools you'll need are: a Phillips screwdriver, and you'll either need an 8 millimeter socket with a ratchet and two inch extension or a T25 Torx driver.
Start by removing the 4 screws that hold this soleplate down. Fast-forward as I remove those screws. Now, on this kick panel here, I'm going to reach down underneath, and pull out. Right underneath is your fan. I'm going to disconnect it. There is a kind of a button coming in from the outside. Press that there and then pull down on the connector. It takes a little bit of force. On these screws you can either use a T25 Torx driver or an 8 millimeter socket with a ratchet. I'm going to speed up here again. You can see I start with the T25 Torx driver. That rear one that's kind of in the corner is a little more difficult, so I go with the 8 millimeter socket and ratchet. Probably the perfect tool is your 8 millimeter socket with a ratchet and a 2 inch extension. Now, as I'm taking that last screw out, the motor pretty much falls down. It comes right out.
The new motor from 1A Auto is exactly the same as the one that came out. Going to have this larger section, go over in there. Speed it up here again. You push the motor up in there. Start the 3 bolts in. I always start them first. Then use your socket and ratchet or your T25 Torx driver to tighten them up. I'll turn the key on, run a quick test. Once you've confirmed it, turn it back off and shut the key off. Now, fit that kick panel back in and it snaps back in place and then your sill plate snaps back in. We'll speed it up here as we put the four screws back in and tighten them up with a Phillips screwdriver.
We hope this helps you out. Brought to you by www.1AAuto.com, your source for quality replacement parts and the best service on the Internet. Please feel free to call us toll-free, 888-844-3393. We're the company that's here for you on the Internet and in person.
Tools used
