Replaces

1996-00 Honda Civic Exterior Door Handle Rear Pair - 1ADHS00848

These replacement exterior door handles are just what you need to get your vehicle in good looking form again!

Specifications:

  • Comes as a PAIR
    • Fits both LH (Driver Side) & RH (Passenger Side) REAR DOORS
  • Smooth Black Finish
    • Can be painted by buyer to match or installed as is
  • Replaces dealer part numbers: 72640-S04-003, 72640-S04-0030, 72680-S04-003, 72680-S04-0030, 72640S04003, 72640S040030, 72680S04003, 72680S040030
  • Durable construction
  • Direct replacements
  • Built to strict quality control standards
  • Fit Japan Built Models only
    • 1st VIN Digit "J"

These exterior door handles are great replacements and have good cost savings over dealer units.

Paint To Match Note:

"Paint to match finish" refers to a smooth, paintable surface. This item will be shipped unpainted but will be ready for paint. Final preparation is suggested for better paint coverage and adhesion. 

This part can also be installed without painting if desired. 

Lifetime Warranty

This item is backed by a Limited Lifetime Warranty. In the event this item should fail due to manufacturing defects during intended use, we will exchange the part free of charge (excludes shipping charges) for the original purchaser. Please keep your invoice for proof of this warranty.

  1. step : Removing the Door Panel (0:38)
    • Pry off the door pull panel with a flat blade screwdriver
    • Remove the two Phillips head screws from the door pull
    • Remove the Phillips screw from the inside door handle
    • Disconnect the window switch wiring harness
    • Pull the inside door handle out
    • Unclip the latch rod from the inside door handle
    • Pull off the inside door handle
    • Pry off the door panel by hand
    • Lift the door panel up and off
    • Carefully peel back the water shield
  2. step : Removing the Outside Door Handle (1:59)
    • Remove the three Phillips screws from the outside door handle
    • Pull the latch rod and lock rod out of their clip
    • Push the black clip through the door
    • Push down the door latch
    • Remove the two 10mm bolts from the door handle
    • Pull the door handle out from the outside of the door
    • Unclip the door handle from the latch rod with a flat blade screwdriver
  3. step : Installing the New Outside Door Handle (3:05)
    • Push the latch rod into the new door handle
    • Push the door handle into the door
    • Insert the two 10mm bolts into the door handle
    • Push the black clip into the door
    • Push the latch rod and lock rod into the white clip
    • Push the door handle into place
    • Insert the three Phillips screws into the door handle
  4. step : Reinstalling the Door Panel (4:10)
    • Put the water shield into place, pulling the window switch wiring harness through it
    • Lift the door panel into place
    • Push in the door panel clips
    • Connect the window switch wiring harness
    • Clip the latch rod into the inside door handle
    • Push the inside door handle into place
    • Insert the Phillips screw into the inside door panel
    • Insert the two Phillips screws into the door pull
    • Snap on the door pull panel

Tools needed for replacement:

    Ratchets & Related

  • Socket Extensions
  • Ratchet

  • Screwdrivers & Related

  • Phillips Head Screwdriver
  • Flat Blade Screwdriver

  • Sockets - Metric

  • 10mm Socket

  • Wrenches - Metric

  • 10mm Wrench

There are no reviews for this item. Write Review
Start typing your question and we'll check if it was already asked and answered. Learn More
No questions have been asked about this item. Be the first!

Vehicle Fit

  • 1996-2000 Honda Civic (Japan Built Models (1st VIN Digit J)) Smooth - Paint to Match Black Exterior Door Handle Rear Pair
Only 5 left in stock
Part #: 1ADHS00848

Ships Same Day for orders placed by 4 P.M. ET

How-to Video:

(05:47 min)