1995-05 Chevrolet Cavalier Pontiac Sunfire Rear Strut & Spring Assembly Pair KYB Strut-Plus KYSSP00480

In the past, replacing struts required specialized tools to compress, remove and transfer the old spring and mount.  Pre-assembled with all new parts, our complete strut and spring assemblies make this job much quicker and easier for the do-it-yourself mechanic.

Each complete strut & spring assembly contains:

• Upper Strut Mount
• Strut Bearing
• Coil Spring
• Boot & Bumper Kit
• Gas-charged Strut 

Why Buy KYB Strut-Plus?

KYB Strut-Plus parts come preassembled and allow for easier replacement over bare units. Some of their perks include:

• Equal or greater OE performance
• Calibrated to OE specifications
• Brand new coil spring, mount, boot, and bumper
• Nitrogen gas-charged design made of quality materials

Restore original ride comfort, handling, and suspension capability

Loaded strut & spring assemblies allow for a quicker, safer install than bare struts.  No spring compressor required! 

Includes the matched parts needed. New components over reused parts provide a better ride and save you from having to repair again.

Item Condition: New

Lifetime Warranty

This item is backed by our limited lifetime warranty. In the event this item should fail due to manufacturing defects during intended use, we will replace the part free of charge.

step : Removing the Rear Strut (1:11)

• Pull back the insulation in the trunk and remove the 13mm nut above the strut.
• Loosen the lug nuts. Raise the vehicle and remove them the rest of the way. Pull the wheel off.
• Spray penetrating oil on the 19mm bolt on the lower end of the strut.
• Lift up on the wheel and remove the bolt.
• Remove the two 10mm bolts at the top of the strut.
• Pull the strut down and out.

step : Replacing the Rear Strut (2:50)

• Put the strut up into place and thread the two 10mm bolts.
• Pull up on the wheel and push the 19mm bolt into place.
• Make sure the strut is properly in place and tighten the two 10mm bolts. 30ft/lbs.
• Torque the 19mm bolt to 55ft/lbs.
• Put the wheel on and replace the lug nuts. Lower the vehicle and tighten the lug nuts in a star patter to 75ft/lbs.
• Replace the 13mm nut in the trunk.