1995-05 Chevrolet Cavalier Pontiac Sunfire Rear Driver & Passenger Side 2 Piece Exterior Door Handle Set DIY Solutions

Complete Repair in One Purchase - Stop searching for parts individually and complete your repair with a single purchase of a customized kit or set from DIY Solutions.

High-Quality Parts from Trusted Brands - DIY Solutions' kits and sets are selected from the best automotive brands and include hard-to-find and even obsolete parts you may need for your vehicle.

Guaranteed Fit - DIY Solutions ensures its selected parts are quality-tested to guarantee fit and function.

Item Condition: New

Lifetime Warranty

This item is backed by our limited lifetime warranty. In the event this item should fail due to manufacturing defects during intended use, we will replace the part free of charge. This warranty covers the cost of the part only.

step : Removing the Door Panel (0:37)

• Pry off the trim piece inside the door handle with a flat blade screwdriver
• Remove the Phillips head screw inside the door handle
• Remove the two Phillips screws at the bottom of the door panel
• Pry out the door panel with a door panel clip tool or putty knife
• Lift the door panel up and off
• Remove the clip from the door lock rod
• Remove the door lock rod
• Disconnect the window wiring harness

step : Removing the Door Handle (1:46)

• Carefully peel back the water shield
• Unclip the lock rod from the door handle
• Remove the two 8mm nuts from the door handle
• Pull the door handle off from the outside

step : Installing the Door Handle (3:14)

• Unclip the lock rod from the old handle
• Clip the lock rod onto the new handle
• Put the handle into place
• Fasten the two 8mm nuts onto the door handle
• Clip the lock rod into place
• Put the water shield into place

step : Reinstalling the Door Panel (5:01)

• Connect the window wiring harness
• Connect the door lock rod to the door handle
• Reclip the clip to the door lock rod
• Lift the door panel into place
• Push in the door panel clips
• Insert the two Phillips screws at the bottom of the door panel
• Insert the Phillips head screw inside the door handle
• Push on the trim piece inside the door handle