This Crown Victoria or Grand Marquis front door handle is just what you need to get your car in good working order again!

Specifications:

  • LH (Driver Side) FRONT
  • Reinforced from the original design
  • Replaces dealer part numbers: 6W7Z-5422405-A, 6W7Z5422405A, F5AZ-5422405-A, F5AZ5422405A, XW7Z-5422405-BA, XW7Z5422405BA
  • Injection molded plastic with Chrome finish & Black handle
  • Handle bezel is a chrome finish NOT a stick on cover

This part is built to strict quality control standards. It is a great replacement and has substantial cost savings over a dealer unit.

Lifetime Warranty

This item is backed by a Limited Lifetime Warranty. In the event this item should fail due to manufacturing defects during intended use, we will exchange the part free of charge (excludes shipping charges) for the original purchaser. Please keep your invoice for proof of this warranty.

  1. step : Removing the Door Panel (0:43)
    • Pry up the window switch panel with a flat blade screwdriver
    • Disconnect the window switch wiring harnesses
    • Pry off the two trim pieces inside the door pull with a flat blade screwdriver
    • Pry off the inner door handle bezel with a flat blade screwdriver
    • Remove the five Phillips screws from the door panel
    • Lift the door panel up and off
    • Disconnect the wiring harnesses from the door panel
    • Carefully peel off the water shield
  2. step : Removing the Outer Door Handle (4:06)
    • Unclip the latch rod
    • Punch out the two door handle rivets with a hammer and punch
    • Drill out the rivets with a 3/8" drill bit
    • Lift the door handle up and out
    • Unclip the lock rod from the door handle
    • Punch out the remains of the rivets with a hammer and screwdriver
  3. step : Installing the Outer Door Handle (7:13)
    • Clip the door handle onto the lock rod
    • Put the door handle into place
    • Insert rivets into the door handle with a rivet gun
    • If you do not have a rivet gun, insert two coarse threaded bolts into the handle
    • Clip on the lock rod
  4. step : Installing the Door Panel (10:11)
    • Put the water shield into place
    • Connect the wiring harnesses to the door panel
    • Lift the door panel into place
    • Insert the five Phillips screws into the door panel
    • Connect the window switch wiring harnesses
    • Push in the window switch panel
    • Slide on the inner door handle bezel
    • Push in the two door pull trim pieces

Tools needed for replacement:

    Drills, Drill Bits & Related

  • Drill
  • 3/8 Inch Drill Bit

  • General Tools

  • Hammer
  • Flashlight
  • Center Punch

  • Materials, Fluids, and Supplies

  • Coarse Threaded Bolts (to replace rivets)
  • Painter's Tape

  • Screwdrivers & Related

  • Phillips Head Screwdriver
  • Flat Blade Screwdriver

  • Specialty Tools

  • Rivet Gun & Rivets

There are no reviews for this item. Write Review
Start typing your question and we'll check if it was already asked and answered. Learn More
No questions have been asked about this item. Be the first!

Vehicle Fit

  • 1992-2011 Ford Crown Victoria Front Chrome & Black Exterior Door Handle Driver Side
  • 1992-2011 Mercury Grand Marquis Front Chrome & Black Exterior Door Handle Driver Side

This part replaces:

  • Partslink FO1310111
  • OE # 6W7Z 5422405 A
  • Dorman 77332
Part #: 1ADHE00243

How-to Video:

(12:57 min)