Replaces

2000-2004 VW Jetta Power Window Regulator (without Motor) Front Pair

Part Details

  • Operation: Power
  • Location: Front
  • Quantity: Pair

This part replaces:

  • DORMAN 740-924,740-925
  • OE # 1J4837461F,1J4837462F

  • New

These replacement window regulators are just what you need to get your vehicle in good shape again!

Specifications:

  • Comes as a PAIR
    • Fits both the LH (Driver Side) & RH (Passenger Side) FRONT DOORS
  • DO NOT include the power window motors
  • Replaces dealer part numbers: 1J4837461F, 1J4837462F
  • Built to strict quality control standards

For vehicles needing info with a production date: You can find the production date of your vehicle on either the outer edge of the driver's front door or on the latch piller that the door closes on.

For vehicles needing info with a VIN code: You can find your vehicles VIN (vehicle identification number)in the driver's side lower corner of the windshield near the A pillar, on your title, or on your state registration.

This Volkswagen Golf and Jetta power window regulator makes a great replacement and has good cost savings over a dealer unit.

Please Note: We are committed to offering the absolute best value for our customers. If you want a highest quality window regulator at a great price, please see our other "High Quality" window regulator listings. If price is your main concern, we are offering this economy style window regulator as well. It is the same one that most internet sellers are offering. While this window regulator is a good replacement, it is not backed by the same warranty as our high quality regulator.

Installation

  • This repair is easier than you may think. You'll find our installation videos helpful. In our experience removing and replacing the door panel is the most involved step in the repair. On most vehicles this only requires removing a few screws and push in clips.
  • You'll get a great feeling of accomplishment after you complete this repair knowing you saved money,and you didn't have to give up your car for a day at the repair shop. Your passengers and other drivers will be amazed.

Fit guaranteed

  • 1A Auto will refund you with no hassle, if this Window regulator does not fit the application stated.
  • You can use your existing hardware and wiring harnesses. This Regulator will install just as your original does. Save time and money.

Quality

  • Be confident this part will work right. Every regulator is tested after assembly to make sure all mechanisms are working correctly.
  • It is important that your new regulator works for a long period of time. The design of this regulator is tested to withstand 10,000 cycles. That is enough to raise and lower your window 3 times per day for 9 years.
  • Nothing is more frustrating than taking your car apart and finding the part you purchased does not fit. You want the part to fit. This design is test fit on an actual door. When you install it, you will have no issues.

Value

  • Windows that don't work can be frustrating. They can also hurt your vehicles value. An inoperable window could mean $200-$500 discounted off a dealer trade value or asking price.
  • Some shops and dealers charge more for parts and repairs when they think you don't know what is involved. Now you can get the value you deserve. Knowing what this repair entails can be the difference between the value of doing it yourself, or the pain of a costly repair bill.

2 Year Warranty

This item is backed by a 2 Year  Manufacturers Warranty. In the event this item should fail during intended use, we will exchange the part free of charge (excludes shipping charges) for the original purchaser. Please keep your invoice for proof of this warranty.

  1. Removing the Door Panel
    • Pry off the door pull panel with a flat blade screwdriver
    • Pull the window switch panel up and out
    • Disconnect the window switch wiring harness
    • Remove the three Phillips head screws from behind the door pull
    • Remove the three T20 Torx bolts
    • Remove the Phillips screw from the front top corner of the door panel
    • Pry the door panel off by hand
    • Pull the door panel up and off the window sill
    • Pull the door handle cable out of the door cable
    • Disconnect the door lock wiring harness
    • Disconnect the courtesy light wiring harness
    • Disconnect the remaining wiring harnesses
  2. Removing the Window Regulator Panel
    • Disconnect the mirror wiring harness
    • Disconnect the speaker wiring harness
    • Disconnect the window motor wiring harness with a flat blade screwdriver
    • Pull the wiring from the tabs in the regulator panel
    • Pull out the wiring gasket
    • Flip down the rubber window covers
    • Remove the three T30 bolts from the window motor
    • Remove the window motor
    • Raise the window by hand
    • Remove the two T20 bolts from the window clamps
    • Separate the window from the window clamps
    • Remove the 10mm bolts from the regulator panel
    • Push the clip back through the regulator panel
    • Slide the regulator panel back and down
    • Push the door handle cable through the panel
    • Push the tab out of the door
    • Angle the regulator panel down and lift the panel off of the lock rod, pushing the gasket through
    • Disconnect the lock rod wiring harness
  3. Assembling the New Regulator Panel
    • Remove the rubber caps from the regulator panel
    • Remove the wiring harness clips with needle nose pliers
    • Remove the speaker cover
    • Drill out the four rivets that hold the speaker
    • Pry off the speaker with a flat blade screwdriver
    • Insert the speaker into the new regulator panel
    • Insert the rivets into the speaker with a rivet gun
    • If you don’t have a rivet gun, use coarse-threaded bolts
    • Put the speaker cover onto the speaker
    • Insert the wiring harness clips into the new regulator panel
    • Push the rubber caps into the new window regulator
  4. Installing the New Window Regulator
    • Pull the lock rod wiring harness through the regulator panel
    • Push the wiring gasket into place
    • Reconnect the lock rod wiring harness
    • Push the door handle cable and gasket through the panel
    • Put the lock rod and gasket through the panel
    • Push the panel into place, being sure not to pinch the wiring harnesses
    • Insert the 10mm bolts into the regulator panel
    • Loosen the 10mm bolts on the window clamps
    • Slide the window into its clamps
    • Tighten the 10mm clamp bolts
    • Put the rubber caps on
    • Push the window motor into place
    • Insert the three T30 bolts into the motor
    • Reconnect all the wiring harnesses to the regulator panel
    • Push the window motor harness tab up to lock the harness in place
    • Push the wiring onto the wiring clips
    • Hold the wiring to the clips with electrical tape if necessary
  5. Reinstalling the Door Panel
    • Reconnect the wiring harnesses to the door panel
    • Attach the door handle cable to the door handle
    • Slide on the door handle cable clip
    • Slide the panel into place
    • Pull the window switch wiring harness through the door pull cavity
    • Push the door panel clips in
    • Insert the three Phillips head screws into the door pull
    • Insert the three T20 screws into the bottom of the door panel
    • Insert the Phillips head screw into the door panel
    • Reconnect the window switch wiring harness
    • Push the window switch panel into place
    • Push the door pull panel into place

How-to Video:

(12:31 min)

Tools List:

    Drills, Drill Bits & Related

  • 5/16 Inch Drill Bit
  • Drill

  • Materials, Fluids, and Supplies

  • Coarse Threaded Bolts (to replace rivets)
  • Electrical Tape

  • Pliers, Cutters & misc Wrenches

  • Needle nose pliers

  • Ratchets & Related

  • Ratchet

  • Screwdrivers & Related

  • Flat Blade Screwdriver
  • Phillips Head Screwdriver

  • Sockets - Metric

  • 10mm Socket

  • Specialty Tools

  • Rivet Gun & Rivets



This part replaces:

  • DORMAN 740-924,740-925
  • OE # 1J4837461F,1J4837462F

Vehicle Fit

  • 1999 VW Golf 4 Door (Built After 10/01/98 Production Date) Power Window Regulator (without Motor) Front Pair
  • 2000-2006 VW Golf 4 Door Power Window Regulator (without Motor) Front Pair
  • 1999 VW Jetta (Built After 10/01/98 Production Date) Power Window Regulator (without Motor) Front Pair
  • 2000-2004 VW Jetta Power Window Regulator (without Motor) Front Pair
  • 2005 VW Jetta (8th Vin Digit J or M) Power Window Regulator (without Motor) Front Pair
$99.95
Save 44%
List: $180.04 Save: $80.09
Part #: 1AWRK00340

Out of Stock

Free GROUND SHIPPING

Check Shipping Rates

We're here to help

Customer Feedback

Customer Feedback
"Thanks for the fast reliable service. Great price, and the headlights were as good as oem or better!!! Keep up the good work..."
- Dwuan M.
Read More
Free Shipping!
OR
CALL
TOLL
FREE

888-844-3393

hablamos Español:866-401-3393
SHIPS SAME DAY
For Orders Placed By 5pm Est