Replaces
Assemblies may include halogen or incandescent test bulbs that should be replaced before installation.
Features and Benefits
Item Condition:
New
Attention California Customers:
WARNING: This product can expose you to chemicals including Chromium (Hexavalent Compounds), which is known to the State of California to cause cancer, and birth defects or other reproductive harm. For more information, go to www.P65Warnings.ca.gov
This item is backed by our limited lifetime warranty. In the event this item should fail due to manufacturing defects during intended use, we will replace the part free of charge. This warranty covers the cost of the part only.
The bulbs are for testing and not covered under our warranty. Our warranty applies to the light assembly only.
FREE Shipping is standard on Orders shipped to the lower 48 States (Contiguous United States). Standard shipping charges apply to Hawaii, Alaska and US Territories. Shipping is not available to Canada.
Expedited is available on checkout to the United States, excluding Alaska, Hawaii and US Territories as well as P.O. Boxes and APO/FPO/DPO addresses. Final shipping costs are available at checkout.
Created on:
Tools used
Brought to you by 1AAuto.com, your source for quality replacement parts and the best service on the Internet.
Hi, I'm Mike from 1A Auto. I hope this how-to video helps you out, and next time you need parts for your vehicle, think of 1AAuto.com. Thanks.
In this video, we're going to show you how to service the parking light on this 2001 Sequoia, same as any '01 to '04. We're going to show you both the bulbs as well as changing the entire light if one was broken. The only tool you'll need is a Phillips screwdriver.
You want to start out there's a little clip on here. Use a Phillips screwdriver and lightly turn in this center portion. It should come up and out. Once you get that up and out, the whole clip will come right out. Now, you just kind of get your light to move ground a little bit and then pull forward. You just lift the change bulbs.
I'll give you two ways: there are connectors on here and you just press the tab and disconnect them. These twist counterclockwise and the bulb comes out. The bulbs just pull out of these sockets. Put it back in. We'll put it back in, twist it clockwise to lock.
Nice new light from 1A Auto. Obviously great if you've broken one. It's going to go in just like the original. Plug it in first. There's a large line up tab here. Make sure that goes into the fender. Then this clip needs to clip into the headlight. Put that in there. Also up here, this goes right under the fender here. Push it back in. You should be all set.
Give it a little tap. It's back in place nicely. This clip is designed to just go in. Then you just push the middle down to lock it into place.
We hope this video helps you out. Brought to you by www.1AAuto.com, your source for quality replacement parts and the best service on the Internet. Please feel free to call us toll-free, 888-844-3393. We're the company that's here for you on the Internet and in person.
