Replaces

2000-2005 Chevy Monte Carlo Turn Signal Wiper Switch with Cruise Control (with Cruise Switch on Steering Wheel)

This part replaces:

  • OE # 26085931. 26093874, 88964581
  • STANDARD MOTOR PRODUCTS CBS-1150

  • New

This combination wiper and turn signal switch lever is a new, aftermarket replacement part. It is designed to REPLACE original units that are prone to failure. It's just what you need to get your vehicle in good working order again!

Specifications:

  • Replaces dealer part number(s): 26085931. 26093874, 88964581
  • Direct replacement
  • Design improved for more durability
  • Detailed graphics
  • Built to strict quality control standards
  • Correct for models:
    • That do not have cruise control at all
    • That do not have on/off cruise control function on turn signal lever

This combination lever is designed to replace your original with no modifications necessary.

Lifetime Warranty

This item is backed by a Limited Lifetime Warranty. In the event this item should fail due to manufacturing defects during intended use, we will exchange the part free of charge (excludes shipping charges) for the original purchaser. Please keep your invoice for proof of this warranty.

  1. Removing the Lower Panel (0:43 in the video)
    • Push the tabs on the panel beneath the steering wheel
    • Remove the panel
    • Twist the socket and remove the bulb from the panel
    • Remove the two 7mm screws from the lower panel
    • Pull out the fuse panel door
    • Remove the lower panel by pulling on both sides
    • Remove the wiring harness from the lower panel with a flat blade screwdriver
  2. Removing the Steering Wheel Panels (1:37 in the video)
    • Remove the T25 screw from beneath the steering wheel
    • Pry out on the tilt lever on the lower steering wheel panel
    • Remove the lower steering wheel panel
    • Remove the two E5 External Torx bolts from each side of the upper panel
    • Remove the upper steering wheel panel
  3. Removing the Turn Signal Switch (2:37 in the video)
    • Remove the two T25 Torx bolts from the signal switch
    • Use a 1/4 inch wrench and a T25 Torx bit if needed
    • Pull the turn signal down and clip the first wire tie
    • Pull on the tab and twist the second wire tie
    • Pull the lever back and disconnect the turn signal switch wiring harness
    • Clip any remaining wire tires
    • Disconnect any remaining wiring harnesses
  4. Installing the New Turn Signal Switch (4:26 in the video)
    • Feed the harness into the dash and reconnect any wiring harnesses
    • Re-clip the clip/wire tie to the wires
    • Connect the turn signal switch wiring harness
    • Feed the turn signal switch into place
    • Insert the two T25 Torx bolts
    • Tilt the wheel up and wire tie the signal switch wires
  5. Installing the Steering Wheel Panels (6:05 in the video)
    • Tilt the steering wheel down
    • Insert the upper steering wheel panel
    • Replace the two E5 inverted Torx bolts
    • Insert the lower steering wheel panel by re-clipping the hooks
    • Insert the T25 screw from beneath the steering wheel
  6. Installing the Lower Panel (6:59 in the video)
    • Connect the wiring harness
    • Push in the lower panel
    • Insert the two 7mm screws from the lower panel
    • Push the bulb into the socket
    • Push in the tabs on the panel beneath the steering wheel
    • Push the tilt lever back into place
    • Push in the fuse panel door

Tools needed for replacement:

    Materials, Fluids, and Supplies

  • Wire Ties

  • Pliers, Cutters & misc Wrenches

  • Wire Cutters

  • Ratchets & Related

  • Ratchet

  • Screwdrivers & Related

  • Flat Blade Screwdriver

  • Sockets - Metric

  • 7mm Socket

  • Torx Drivers & Sockets

  • E5 Inverted Torx Socket
  • T25 Torx Driver

  • Wrenches - SAE

  • 1/4 Inch Wrench

How-to Video:

(08:24 min)

Tools List:

    Materials, Fluids, and Supplies

  • Wire Ties

  • Pliers, Cutters & misc Wrenches

  • Wire Cutters

  • Ratchets & Related

  • Ratchet

  • Screwdrivers & Related

  • Flat Blade Screwdriver

  • Sockets - Metric

  • 7mm Socket

  • Torx Drivers & Sockets

  • E5 Inverted Torx Socket
  • T25 Torx Driver

  • Wrenches - SAE

  • 1/4 Inch Wrench



This part replaces:

  • OE # 26085931. 26093874, 88964581
  • STANDARD MOTOR PRODUCTS CBS-1150

Vehicle Fit

  • 2000-2005 Chevy Impala Turn Signal Wiper Switch with Cruise Control (with Cruise Switch on Steering Wheel)
  • 2000-2005 Chevy Impala Turn Signal Wiper Switch (without Cruise Control)
  • 2000-2005 Chevy Monte Carlo Turn Signal Wiper Switch (without Cruise Control)
  • 2000-2005 Chevy Monte Carlo Turn Signal Wiper Switch with Cruise Control (with Cruise Switch on Steering Wheel)
$73.95
Save 86%
List: $520.00 Save: $446.05
Part #: 1AZCC00175

- Ships Same Day for orders placed by 5 P.M. ET

Free GROUND SHIPPING

Check Shipping Rates

We're here to help

Customer Feedback

Customer Feedback
"Thanks for the fast reliable service. Great price, and the headlights were as good as oem or better!!! Keep up the good work..."
- Dwuan M.
Read More
Free Shipping!
OR
CALL
TOLL
FREE

888-844-3393

hablamos Español:866-401-3393
SHIPS SAME DAY
For Orders Placed By 5pm Est