How to Replace Windshield Wiper Motor Linkage 2004-10 Dodge Ram
Created on: 2016-08-16
With this video you can learn how to replace the windshield wiper motor & linkage on your 04-10 Dodge Ram. 1AAuto shows you how to do it yourself!
-
step 1 :Removing the Wiper Arms
- Lift the wiper arm up
- Pull out the tab on the end of the arm
- Slide the arm off the splines
-
step 2 :Removing the Wiper Cowl Cover
- Remove the T25 Torx screws from both ends of the cowl
- Pry out the snap clips from the cowl with side cutters
- Remove the deadening material
- Remove the weatherstrip
- Lift up the passenger side wiper cowl
- Disconnect the washer hoses from their retainers
- Remove the passenger side wiper cowl
- Remove the clips from the driver's side
- Remove the wiper cowl cover from the vehicle
-
step 3 :Removing the Wiper Motor and Linkage
- Disconnect the wiper motor electrical connector
- Remove the three 10mm bolts from the wiper linkage
- Remove the wiper motor and transmission assembly
-
step 4 :Installing the Wiper Motor and Linkage
- Change over the rubber protector piece to the new wiper motor and linkage
- Insert the wiper motor and linkage into place
- Tighten the three 10mm bolts to the wiper linkage
- Connect the wiper motor electrical connector
-
step 5 :Installing the Wiper Cowl Cover
- Insert the wiper cowl into place
- Press the clip connectors into place
- Snap the washer hoses into the cowl cover
- Realign the passenger side cowl cover
- Insert the weatherstrip into the cowl
- Tighten the two T25 Torx screws
-
step 6 :Reinstalling the Wiper Arms
- Press the arm onto the splines
- Close the clip
- Lay the wiper arm down
Tools needed
-
Socket Extensions
10mm Socket
Ratchet
Wire Cutters
T25 Torx Driver
Brought to you by 1AAuto.com, your source for quality replacement parts and the best service on the Internet.
Hi, I'm Mike from 1A Auto. I hope this how-to video helps you out, and next time you need parts for your vehicle, think of 1AAuto.com. Thanks.
In this video, we're going to show you how to remove and reinstall the wiper cowl cover in this 2008 Dodge Ram 1500.
Here are the items you'll need for this repair: T25 Torx Drivers, side cutters
Remove the wiper arms from the truck. You have to lift up. Small tab here that you take out with your thumb. It simply lifts off the splines. Using a T25 Torx bit ratchet and extension, remove the T25 Torx screws on both ends of the wiper cowl. Open your hood.
We're going to use a pair of side cutters to remove all of these plastic snap clips here. It makes them a lot easier to pry out. What you want to do is open them up, slide them underneath, and close down without cutting. Simply work it back and forth. Repeat this for the remaining clips all the way down the bottom of the wiper cowl.
We'll also remove this clip on the insulation. Pull that back. Lift up on the weather strip here. That simply pulls off. Now we can remove the passenger side of our wiper cowl. Disconnect the windshield washer lines there. Remove the remaining three clips. Take off our driver's side. Remove the wiper cowl cover.
Reinstall your wiper cowl. Reconnect to your plastic clip connectors. Reconnect the washer hoses. Snap them down into the retainers. Reinstall plastic clips. Lay this deadening material back across. Stick this harness retainer in and the other clip. Lay the weather strip across the bottom of the cowl. Snap it onto its retainer in the middle here. Close your hood. Reinstall the two Torx screws at the rear of the cowl. Reinstall the wiper arms onto the splines.
Thanks for tuning in. We hope this video helped you out. Next time you need parts for your car, please visit 1AAuto.com. Also check out our other helpful how-to and diagnosis videos.
2004-05 Dodge Ram 1500 2500 3500 Wiper Motor, Linkage, & Jumper Harness Mopar MPERK00002
- (1) Windshield Wiper Motor & Linkage
- (1) Wiper Motor Jumper Harness (Oval Connector to Square)
How to Replace Windshield Wiper Transmission 1995-2000 Chevy Tahoe
How to repair, install, fix, change or replace a broken, bent, damaged, failing or squeaking windshield wiper transmission on 95, 96, 97, 98, 99
