How to Replace Throttle Body 2009-16 Ford Escape

1. step 1 :Removing the Air Intake Tube 0:31

   • Press the lock and disconnect the MAF sensor connector
   • Unclip the connector wiring from the air intake tube
   • Loosen the hose clamps with a flat blade screwdriver
   • Disconnect the vacuum hose from the air intake tube

2. step 2 :Removing the Throttle Body 1:33

   • Disconnect the throttle body electrical connector with a pick
   • Remove the 8mm bolts from the throttle body
   • Remove the throttle body

3. step 3 :Installing the Throttle Body 3:26

   • Remove the old gasket with a 90 degree pick
   • Press the new gasket to the mating surface
   • Press the throttle body into place
   • Tighten the 8mm bolt to the throttle body
   • Torque the 8mm bolts to 89 inch-pounds
   • Connect the throttle body connector

4. step 4 :Installing the Air Intake Tube 4:53

   • Connect the vacuum line to the intake tube
   • Insert the air intake tube into place
   • Tighten the hose clamps with a flat blade screwdriver
   • Clip in the MAF sensor wire
   • Connect the MAF sensor electrical connector

5. step 5 :Testing the Throttle Body 5:40

   • Start the vehicle and let the engine idle for some time
   • Wait for the engine stabilize and drop to normal idle range
   • Rev the engine a few times to test
   • Test drive the vehicle at 5 mph and then road test the vehicle

Tools needed

• Socket Extensions

  Flat Blade Screwdriver

  Torque Wrench

  8mm Socket

  Ratchet

  Pick