How to Replace Rear Window Switch 2010-16 Cadillac SRX
Created on: 2018-08-24
How to repair, install, fix, change or replace a damaged, worn out, faulty or shorted power window switch on 13 Cadillac SRX
-
step 1 :Removing the Rear Window Switch
- Pry up the window switch with a trim tool
- Disconnect the window switch harness
- Press the tabs on the switch with a flat blade screwdriver
- Remove the switch
-
step 2 :Installing the Rear Window Switch
- Clip the switch to the trim
- Connect the wiring harness
- Press the switch into place
Tools needed
-
Flat Blade Screwdriver
Trim Tool Set
Hi, I’m Mike from 1A Auto. We’ve been selling auto parts for over 30 years!
We're going to remove this trim piece right here and use a trim tool. And slide under here. Pry up a little bit, and pry it up like that. These are the retainers that were holding it on. That one was holding up a little bit. Just push down on that. And then we will disconnect the electrical connector. Just going to push this button right here, and pull out the connector.
To get the window switch out we're going to take a small flat blade screwdriver and there's some retainers right here. I am going to put a little bit of pressure on the switch as I pry out on these retainers on that side. And then I'll do the same on this side. And push the switch right out. And it will pop out.
To install the switch, make sure it's facing the proper direction. And we'll slide it in like this. And lock it in place. I am going to connect this electrical connector to the window switch. Just line it up, lock it in place. You can take this trim, line the retainers up there and there. And you can just push it down, lock it in place.
Thanks for watching. Visit us at 1AAuto.com for quality auto parts, fast and free shipping, and the best customer service in the industry.
Why you Should Replace Not Restore Headlights
See why replacing your cloudy headlights with new ones is always better than refinishing them Why should you replace your headlights and not clean or refinish them? Three reasons: It's a simple fix, it increases visibility, and it enhances the overall look of your vehicle. Headlights are made from a polycarbonate plastic that can be damaged by UV rays from the sun or suffer pitting caused by road debris light salt and rocks. If you look closely at an old set of headlights, you'll see that the lens is full of micro-cracks. This is called crazing. This crazing, along with pinning, will turn your headlights from crystal clear to hazy yellow and it cuts the output in half, making it very difficult to see at night. It also makes your car look old and dated. With parts from 1AAuto.com and our how-to videos, you can make your vehicle look new and stay safe on the road. To get new headlights for your vehicle, visit 1AAuto.com and visit our YouTube page for do-it-yourself and how-to videos.
