How to Replace Rear Window Switch 2007-13 Chevy Suburban
Created on: 2017-06-19
New Power Window Switch from 1AAuto.com How to repair, install, fix, change or replace a damaged, worn out, faulty or shorted power window switch on 07, 08, 09, 10, 11, 12, 13, Chevy, Suburban
-
step 1 :Removing the Window Switch
- Pry up the master switch panel with a trim tool
- Disconnect the wiring harnesses
- Press the switch out of the trim
-
step 2 :Installing the Window Switch
- Click the switch into the trim
- Connect the wiring harnesses
- Press the master switch panel into the door panel
Tools needed
-
Flat Blade Screwdriver
Trim Tool Set
Hi, I'm Mike from 1A Auto. We've been selling auto parts for over 30 years. We're dedicated to delivering quality auto parts, expert customer service, fast and free shipping, all backed by our 100% satisfaction guarantee. Visit us at 1AAuto.com, your trusted source for quality auto parts.
If you have good fingernails, sometimes you can just pull up and off on that. You could also use a trim tool available at 1AAuto.com. Put underneath, and pull straight up. Make sure you pull up on the front. Somebody was not that careful on this one, and you can see they actually broke off the tab on the trim.
Then you'll want to disconnect your power window switch, just a little tab here. Pull and disconnect, and remove your old switch. The plastic trim tool is the best tool. Pry out one side, press with your thumb down, and push and release the clamps, and it comes out.
The replacement switch from 1A Auto goes right in, clicks in place.
Reconnect the switch. Feed the harness down in. Make sure you put this in correctly.
Thanks for watching. Visit us at 1AAuto.com for quality auto parts, fast and free shipping, and the best customer service in the industry.
How to Replace Power Window Switch 2001-04 Chrysler Sebring
How to repair, install, fix, change or replace a damaged, worn out, faulty or shorted power window switch on 01, 02, 03, 04 Chrysler Sebring.
