How To Replace Rear Door Panel 2002-07 Jeep Liberty
Created on: 2014-01-23
Watch this video to learn how to remove and replace the rear interior door panel on your 02-07 Jeep Liberty.
-
step 1 :Removing the Door Panel
- Pry off the trim piece inside the door handle with a flat blade screwdriver
- Remove the Phillips head screw inside the door pull
- Remove the Phillips head screw inside the door handle
- Pry out the door panel with a door panel clip tool or putty knife
- Lift the door panel up and off
- Disconnect the latch cables from the door handle
-
step 2 :Installing the Door Panel
- Connect the latch cables to the door handle
- Lift the door panel into place
- Push in the door panel clips
- Insert the Phillips head screw inside the door pull
- Insert the Phillips head screw inside the door handle
- Push in the trim piece inside the door handle with a flat blade screwdriver
Tools needed
-
Flat Blade Screwdriver
Phillips Head Screwdriver
Putty Knife
10mm Socket
Ratchet
Brought to you by 1AAuto.com, your source for quality replacement parts and the best service on the Internet.
Hi, I'm Don from 1A Auto. I hope this how-to video helps you out, and the next time you need a part for your vehicle, think of 1AAuto.com. Thanks.
In this video, we're going to show you how to remove and replace the rear door panel on this 2006 Jeep Liberty. We show you on the passenger side, but the driver side is the same procedure. The items you'll need for this is a Phillips screwdriver, a flat blade screwdriver, a 10mm socket and ratchet, and a putty knife.
Start off by prying up this little panel behind your door handle. Then, there's a Phillips screw in there, and one in the pole cup. Just go ahead and remove those. Using a putty knife or flat blade screwdriver, pry out the door panel so you can get your hand behind it. Then near the clips, pull directly out. This will release those clips. Again, find the clip, pull out.
Then when you get to this point, reach in behind the door panel and push those last two clips along the top out. The door panel lifts up and off. Now on the back of your door handle push this clip off your door handle rod and push it down and out.
Now to reinstall the door panel, push your door handle rod back up into the door handle and reclip it. Then put your door panel down over the lock and onto the window sill. Check behind the door panel, and make sure the clips are lined up. Then hit them into place. Then replace those two Phillips screws and that panel behind the door handle.
We hope this video helps you out. Brought to you by www.1AAuto.com, your source for quality replacement parts and the best service on the Internet. Please feel free to call us toll-free, 888-844-3393. We're the company that's here for you on the Internet and in person.
How to Remove Front Door Panel 2000-05 Dodge Neon
Learn how to remove the front door panel on your 00-05 Dodge Neon. 1A Auto will show you the steps.
