How To Replace Rear Axle ABS Sensor Ford F150
Created on: 2014-12-12
In this video, 1A Auto shows you how to replace a rusted or defective rear axle ABS sensor in a 04-08 Ford F150.
-
step 1 :Removing the ABS Speed Sensor
- Disconnect the sensor wiring harness on the top of the differential
- Remove the 3/8" bolt from the sensor
- Remove the ABS speed sensor with a flat blade screwdriver and hammer
-
step 2 :Installing the ABS Speed Sensor
- Clean the hole from any debris
- Place gear oil around the bottom of the new sensor
- Insert the sensor into place
- Tighten the 3/8" bolt to the sensor
- Connect the sensor wiring harness
Tools needed
-
Gear Oil
Hammer
Flat Blade Screwdriver
Ratchet
3/8 Inch Socket
Brought to you by 1AAuto.com, your source for quality replacement parts and the best service on the Internet.
Hi, I'm Mike from 1A Auto. I hope this how-to video helps you out, and next time you need parts for your vehicle, think of 1AAuto.com. Thanks!
In this video, we're going to show you how to replace the rear axle ABS speed sensor on this 2005 Ford F150. The items you'll need for this are a new rear axle ABS speed sensor from 1AAuto.com, a 3/8"� socket and ratchet, a flat blade screwdriver, and a hammer.
At the top of your rear differential there is this harness. You want to just push on the tab and disconnect the harness. That tab can be a little stiff, so it helps if you use a flat blade screwdriver. Holding the sensor in place is a 3/8"� bolt. Go ahead and remove that.
Now, using a flat blade screwdriver and a hammer, you want to just get the screwdriver underneath the sensor and pry up on it. It actually helps if you use a second flat blade screwdriver to pry at the top. You want to just work at it for a while, and eventually it will pop up. Then you can just pull it free.
Now just clean out, along the inside of this hole, making sure no debris falls into the differential. Then take some gear oil and rub it around the bottom of your new sensor.
Push the sensor into place and make sure it's all the way down into place so that it's fully seated. Then replace that 3/8"� bolt and tighten it up. Reconnect your harness and you're all set.
We hope this video helps you out. Brought to you by www.1AAuto.com, your source for quality replacement parts and the best service on the Internet. Please feel free to call us toll-free, 888-844-3393. We're the company that's here for you on the Internet and in person.
How to Replace ABS Sensor 2002-05 Mercury Mountaineer
Watch this video for detailed instructions on how to replace the ABS sensor on your 02-05 Mercury Mountaineer.
