How to Replace Master Power Window Switch 2005-08 Pontiac G6
Created on: 2013-07-16
How to repair, install, fix, change or replace a damaged, worn out, faulty or shorted power window switch on Pontiac G6, model years 05, 06, 07, 08.
-
step 1 :Removing the Window Switch
- Pry off the trim piece inside the door pull with a flat blade screwdriver
- Remove the two T30 Torx screws inside the door pull
- Pry up the window switch pane with a flat blade screwdriver
- Disconnect the window switch wiring harnesses
- Cut the tape with a razor blade if necessary
- Pry the window switch out of the switch panel with a flat blade screwdriver
-
step 2 :Installing the Window Switch
- Push the window switch into the switch panel
- Connect the window switch wiring harnesses
- Push in the window switch panel
- Insert the two T30 Torx screws into the door pull
- Push the trim piece into the door pull
Tools needed
-
Razor Blade / Gasket Scraper
Socket Extensions
Flat Blade Screwdriver
T30 Bit
Ratchet
Brought to you by 1AAuto.com, your source for quality replacement parts and the best service on the Internet.
Hi, I'm Don from 1A Auto. I hope this how-to video helps you out, and next time you need parts for your vehicle, think of 1AAuto.com. Thanks.
In this video, we're going to show you how to replace the master switch pack, window switch pack on a 2007 Pontiac G6, basically the same operation for 2005 through 2010. You'll need a pocket screwdriver, a Torx 30 bit, a socket wrench, and an extension if you need one.
Using a pocket screwdriver, pry up on the little mat that's inside the door handle or the door pull there, pull it out and you'll see two Torx 30 screws. I'm using a Torx 30 socket, extension, and socket wrench to remove those two screws. I'm going to fast forward as I remove those 2 screws. Pull the handle and switch pack assembly cover out. Remove the three connectors, press the tabs in on the gray and the black, and then, on the white one, use a pocket screwdriver to push the tab out and pull that one out of the way.
Cut the tape with a razor blade if you have any. On both sides of the switch pack, you're going to have two tabs between the housing and the switch pack itself. Use a pocket screwdriver, apply some pressure from underneath where the switches are, do one side, and then pop out the other side, and it should come out.
Install the switch pack. Make sure all four of the clips seat in there and then reinstall the three harnesses: the gray, black, and white. Then press it down into place, lining up the holes. Reinstall the two Torx 30 screws that you took out and I'm going to fast forward through tightening those screws and then reinstall the mat that covers the screws.
We hope this video helps you out. Brought to you by www.1AAuto.com, your source for quality replacement parts and the best service on the Internet. Please feel free to call us toll-free, 888-844-3393. We're the company that's here for you on the Internet and in person.
How to Replace Power Window Switch 2001-06 Dodge Stratus
How to repair, install, fix, change or replace a damaged, worn out, faulty or shorted power window switch on Dodge Stratus, years 01, 02, 03, 04, 05, and 06.
