How to Replace Engine Mount 2001-06 Hyundai Elantra
Created on: 2013-05-19
Learn how to replace the front lower engine mount yourself with this short how-to video
-
step 1 :Removing the Motor Mount
- Raise and secure the vehicle
- Support the engine with a jack
- Remove the four 14mm bolts from the motor mount
- Pull the motor mount down and out
-
step 2 :Installing the Motor Mount
- Lift the motor mount into place
- Insert the four 14mm bolts into the motor mount
- Lower the jack
- Lower the vehicle to the ground
Tools needed
-
14mm Wrench
14mm Socket
Jack Stands
Ratchet
Swivel
Floor Jack
Brought to you by 1AAuto.com, your source for quality replacement parts and the best service on the Internet.
Hi, I'm Don from 1A Auto. I hope this how-to video helps you out, and next time you need parts for your vehicle, think of 1AAuto.com. Thanks.
In this video, we show you how to replace the front lower engine mount on this 2005 Hyundai Elantra. You'll need a jack and jack stands, and then a 14mm socket, a 14mm wrench, and you'll probably need a ratchet that has a flexible handle that helps you get in one of the angles a little better, and you'll see what we mean. This is on a 2005 Elantra, same for any 2001 to 2006 Elantra with a 2.0 liter motor.
Locate your front lower motor mount at the front of the engine, right in front of the transmission, and right behind the subframe. So, I'm supporting the engine between where the engine and transmission mate together. I'm going to locate the four bolts that hold the motor mount in place, this being one, two, the third one over here on the back behind, and the fourth one right here. They're 14-mm. I'll place my socket wrench on this side. I'm going to hold the wrench on this side and remove the nut and bolt. I'm going to use an adjustable angled ratchet for the two that go in vertically to the subframe. This just makes it easier to get to from underneath. To get it out, I'm going to rotate the plate vertically, slide the whole mount up, turning it a little bit and bringing it down the side.
I'm putting the mount back in, and I start all bolts in before I tighten any of them down. Just fast forward here, as we tighten those up. It's a pretty straightforward repair. Locate the mount. Make sure you support the engine, and then remove all four bolts. Lift the mount up and out. Put it back in, and then tighten up all four bolts again.
We hope this video helps you out. Brought to you by www.1AAuto.com, your source for quality replacement parts and the best service on the Internet. Please feel free to call us toll-free, 888-844-3393. We're the company that's here for you on the Internet and in person.
Shop Products
Hyundai Elantra Tiburon Front Engine Mount DIY Solutions EMT00400
Part Details:
- Highest Quality Materials
- Quality Tested - built to a strict level of product standards.
How to Replace Front Engine Mount 2002-06 Nissan Altima
Got a bad engine mount? Follow the steps in this video and replace it yourself!
