Menu

1A Auto Video Library
Our how-to videos have helped repair over 100 million vehicles

How To Replace Engine Air Filter 04-09 Audi A4

Share on:
  1. step : Removing the Air Filter (0:34)
    • Lift up and remove the intermediate duct
    • Remove the two Phillips screws from the air box
    • Remove the air filter from the air box
    • Vacuum out the air box
  2. step : Installing the Air Filter (1:39)
    • Insert the air filter into place
    • Tighten the two Phillips screws to the air box
    • Reconnect the intermediate duct

Brought to you by 1AAuto.com, your source for quality replacement parts and the best service on the Internet.

Hi, I'm Mike from 1A Auto. I hope this how-to video helps you out, and next time you need parts for your vehicle, think of 1AAuto.com. Thanks.

In this video, we're going to show you how to remove and reinstall the air filter on this 2007 Audi A4. This should be a pretty similar procedure for most Audi A4s. This one has the 2.0-liter turbocharged motor in it. The only tool you'll need is a Phillips screwdriver.

Open the driver's door and pull the hood release lever. There's a secondary safety latch in the middle of the hood. Push up on the lever and lift your hood.

Your air filter is on the passenger side. Lift up on the duct work, and then pull that intermediate duct out. Then there are two Phillips screws that hold the air box together. I'll fast-forward as I remove those. On the back of the air box is a little wire clip. Pull that out and then separate the upper air box from the lower air box. Then you can pull your old air filter up and out.

I use a shop vac and just vacuum up any of the leaves, sand, and debris that are down in there.

Separate the top of your air box again, and put your new air filter down in. You may have to push the corners down in a little bit. Once it starts going in, it should go in nice and easy. Make sure it's seated in all the way around. Your air box goes back together. You may have to lift up and reset the clips that are at the bottom, but you want to make sure that it goes together, the screws line up pretty easily. Then we'll speed up here as we tighten up those two screws. Put that wire clip back on and then put your duct back in. Just put the duct down in a little bit. Just make sure it's going into the right area. You don't want to push it down yet. There is a clip on the side of the duct that you want to make sure the wire goes under. Then there's a hose that goes outside of it. Put it down in and then pull on that accordion duct there and line that up. Make sure it goes in properly to the primary air duct there, and then push the whole duct in system in down and it clips in place.

Thanks for tuning in. We hope this video helped you out. Next time you need parts for your car, please visit 1AAuto.com. Also check out our other helpful how-to and diagnosis videos.

Tools needed for replacement:

    Screwdrivers & Related

  • Phillips Head Screwdriver

  • Specialty Tools

  • Vacuum


Brakes too Sticky or Not Working on your Truck?

Brakes too Sticky or Not Working on your Truck?

If your brakes are stuck or smoking, the 1A Auto mechanics in this video will explain a few different causes on these trucks and how you can fix it

Search Videos
Go To Top


Same Day Shipping

Orders ship same day when ordered by 2pm ET. Need your part faster? Choose expedited shipping at checkout.


Guaranteed To Fit

Providing you the highest quality, direct fit replacement auto parts enforced to the strictest product standards.


USA Customer Support

Exceeding customers' expectations every day, our team of passionate auto enthusiasts are here to help.


Instructional Video Library

Thousands of how-to auto repair videos specific to year, make and model guide you step-by-step through your repair.

Loading...