How to Replace Blower Motor Resistor 2011-13 Ford Fiesta

Installation Instructions Steps
Associated Vehicles Fits

Created on: 2019-04-02

How to repair, install, fix, change or replace a bad or broken blower motor fan speed resistor on 11, 12, 13 Ford Fiesta

step 1 :Removing the Blower Motor Resistor
- Loosen the plastic body screw from the center console floor panel with a flat blade screwdriver
- Pull the panel out
- Remove the T20 bolts from the blower motor resistor
- Remove the resistor
- Disconnect the wiring harness
- Examine the connector for melted or burnt terminals
step 2 :Installing the Blower Motor Resistor
- Connect the resistor wiring harness
- Insert the blower motor resistor into place
- Tighten the T20 Torx bolts to the resistor
- Press the center console floor panel on
- Tighten the body screw to the console panel

2008 - 2010 Ford F550 Truck

2008 - 2010 Ford F450 Truck

2005 - 2007 Mercury Montego

2004 - 2004 Ford F150 Truck

2006 - 2008 Lincoln Mark LT

2005 - 2007 Ford Five Hundred

2005 - 2009 Ford Mustang

2004 - 2007 Mercury Monterey

2004 - 2007 Ford Freestar

2005 - 2007 Ford Freestyle

2008 - 2010 Ford F250 Super Duty Truck

2008 - 2010 Ford F350 Super Duty Truck

2005 - 2014 Ford F150 Truck

2007 - 2017 Ford Expedition

2011 - 2013 Ford Fiesta

2008 - 2011 Mercury Mariner

2008 - 2011 Mazda Tribute

2008 - 2012 Ford Escape

2009 - 2014 Lincoln Navigator

Shop Products

Ford Mazda Lincoln Mercury Blower Motor Resistor TRQ HCA40068

Part Details:

Highest Quality Materials
Quality Tested - built to a strict level of product standards.

$34.95

How to Replace Blower Motor Resistor 2008-12 Jeep Liberty

The heat and air condition fan is controlled by a separate module, called the blower motor resistor. The nature of this component’s job causes it to heat up frequently, which can lead to failure. If your vents will only blow one speed, this is likely the cause. TRQ has a new resistor module made specifically for your vehicle. How to install it yourself in your 2008-12 Jeep Liberty.