How to Replace Blower Motor 2014-19 Toyota Tundra
Created on: 2018-04-03
How to repair, install, fix, change or replace a bad or broken blower motor on 14 Toyota Tundra.
-
step 1 :Removing the Blower Motor
- Press the four plastic tabs holding the lower trim panel from beneath the glove box
- Pry the lower trim panel down and out
- Remove the three 8mm screws from the blower motor
- Disconnect the wiring harness
- Remove the blower motor
-
step 2 :Installing the Blower Motor
- Insert the blower motor into place
- Tighten the 8mm screws to the motor
- Connect the wiring harness
- Press the lower trim panel on
Tools needed
-
Socket Extensions
Trim Tool Set
T25 Torx Driver
Hi, I’m Mike from 1A Auto. We’ve been selling auto parts for over 30 years!
There's four plastic tabs holding this lower trim panel on. Right here, over here, right over here, and one over here. Going to reach in sort of pull this down and reach up and push the tab towards the front of the vehicle to unlock it. Save all of them. This one and then it also has a push clip in here. Right there and there's two tabs that this is sitting on in the back so pop it out.
Here are three screws holding the blow motor in. You can either use the eight millimeter or a T25 Torx bit, using that on my extension here. This one here. This one here. This one here. And then this one over here. Start on the one closest to the firewall here. Extension's kind of getting in the way. Get it loose, pull it out with my fingers, and put the other one on here. Before I get too far, we'll unplug the connector which is locking, pull the plug out. The last one here. Hold the blower motor up and place behind the wires. We have the blower motor.
Here is the original blower motor assembly and here is the brand new one from 1Aauto.com. Same exact, style design. Just like the original the new one has the blow motor resistor, it's integrated inside of here. So if you're looking for the resistor, it is contained in the blow motor. Same mounting tabs, same electrical connector plug. This will work great and fit great in your vehicle.
Blower motor back in place. Line up this part of the blow motor with the opening right here. Set it up toward the heater box, past the harness wiring here. This screw caught here. this other caught on the other side. They're just self-tappers going right into plastic, so don't over tighten them, then the final one here behind the harness. And plug it all back in. The blower motor is replaced. We'll reinstall this cover. So these two pins in the corresponding holes where at the firewall, so we push them in there and then lift it up and clip it in place.
Thanks for watching. Visit us at 1AAuto.com for quality auto parts, fast and free shipping, and the best customer service in the industry.
Shop Products
How to Replace Blower Motor 1997-2005 Chevy Venture
Check out this video on how to repair, install, fix, change or replace a broken, weak, noisy or screeching heater and air conditioning fan blower motor
