How to Remove Reinstall Glove Box 2004-07 Subaru Impreza WRX
Created on: 2017-10-27
How to change, replace, remove the broken, unopening, stuck glove box latch on 04 Subaru Impreza WRX
-
step 1 :Removing the Glove Box
- Remove the plastic clip from the side of the glove box with a Phillips screwdriver
- Remove the two Phillips screws from the bottom of the glove box
- Open the glove box
- Empty the glove box
- Remove the five Phillips screws around the glove box
- Remove the two Phillips screws inside the glove box
- Pull the glove box out of the dashboard
- Disconnect the glove box light electrical connector
- Remove the glove box from the vehicle
-
step 2 :Installing the Glove Box
- Connect the glove box light electrical connector
- Put the glove box into place using the locating pin
- Open the glove box
- Insert the five Phillips screws around the glove box
- Insert the two Phillips screws inside the glove box
- Close the glove box
- Insert the two Phillips screws at the bottom of the glove box
- Push the plastic clip into the side of the glove box
Tools needed
-
Flat Blade Screwdriver
Phillips Head Screwdriver
Hi. I'm Mike from 1AAuto. We've been selling auto parts for over 30 years!
Remove this clip. It just screws in. You use a Phillips head screwdriver to pop it out. Pull it right out.
There's a screw here on the bottom and then one over here. Remove those two with a Phillips head screwdriver. Remove that screw. Over here, take this screw out.
Open the glove box. I already emptied it. You need to remove the one, two, three, four, five screws here and the two that are inside the glove box. With all those screws removed, pull the whole dash and glove box assembly out.
There's a little harness for the glove box light snapped into the glove box like this, so I'm just going to push it out by bending the tabs in and just popping out the top. Take a small flat headed screwdriver and push in on this lock. Sometimes if you push it in tighter, then you can push out on the lock. Pull that apart. Take the glove box out.
Your glove box assembly, put it back in so it powers the light. Pop that back in place.
Reinstall the glove box. This pin here is going to snap into here and then reinstall all the screws. It helps if you open the glove box. Get this top screw first. Just reinstall all the screws again. Close the glove box. Install the two screws in the bottom. Finally, reinstall this push clip and screw it in place.
Thanks for watching. Visit us at 1AAuto.com for quality auto parts, fast and free shipping, and the best customer service in the industry.
Memory Seats Have a Mind of Their Own How to Reset and Program Memory Seats
Andy shows you how to reset and program misbehaving power memory seats!
