How to Remove Install Front Seats 1997-2001 Toyota Camry
Created on: 2016-07-26
How to remove, replace and install the front seats in a Toyota Camry to the 97, 98, 99, 00, 01 Toyota Camry
-
step 1 :Removing the Seat
- Remove the two 14mm bolts from the front of the seat base
- Slide the seat forward
- Pull the plastic covers of the rear of the seat base|
- Remove the two 14mm bolts from the rear of the seat base
- Tip the seat back
- Disconnect the wiring harness underneath the seat
- Pry open the wiring harness retainer with a flat blade screwdriver
- Pull the wiring harness off of the sear
- Lay the seat back
- Pull the seat out through the door
-
step 2 :Installing the Seat
- Slide the seat in through the door
- Connect the wiring harness underneath the seat
- Snap the wiring harness into its retainer
- Line the seat up with the base
- Insert the two 14mm bolts into the front of the seat base
- Slide the seat forward
- Insert the two 14mm bolts into the rear of the seat base
- Snap the plastic covers onto the rear of the seat base
- Adjust the seat to its normal position
Tools needed
-
Socket Extensions
Flat Blade Screwdriver
14mm Socket
Ratchet
Brought to you by 1AAuto.com, your source for quality replacement parts and the best service on the Internet.
Hi, I'm Mike from 1A Auto. I hope this how-to video helps you out, and next time you need parts for your vehicle, think of 1AAuto.com. Thanks.
In this video we're going to show you how to remove and reinstall the driver's seat in this 1998 Toyota Camry. The tools you're going to need to do this are a 14 mm socket and ratchet, an extension, and a flat blade screw driver.
Remove the two 14 mm bolts at the front base of the seat with a 14 mm socket and ratchet. Slide the seat all the way forward. Remove the plastic cover on the rear. Remove this and the 14 mm bolt on the other side. You may want to add an extension to your 14 mm socket and ratchet for a little more room to swing. Tip the seat back and disconnect the connector from the bottom of the seat. You may want to remove the clip from its retainer. Use the small flat blade screwdriver to open the retainer for the harness. Remove it from the seat. Lay the seat back as far as you can. Rotate it up. Remove it through the driver's door.
Reinstall the seat into the car. Reconnect the electrical connector under the seat. Snap the connector back into its slot. Line the seat up. Reinstall two 14 mm bolts at the front. Tighten them down with a 14 mm socket and ratchet. Slide the seat all the way forward. Reinstall the 14 mm bolts in the rear of the seat bracket. Tighten them down with a 14 mm socket and ratchet. Snap the plastic cover back into place on the rear outside bracket and put the seat back into its normal position.
Thanks for tuning in. We hope this video helps you out. Brought to you by www.1AAuto.com, your source for quality replacement parts and the best service on the Internet. Please feel free to call us toll-free, 888-844-3393. We're the company that's here for you on the Internet and in person.
Cant Spray Your Cars Windshield Diagnose Broken Washer Nozzles
This video shows you how to diagnose clogged, broken, or leaky washer fluid nozzles and hoses.
