This window regulator is a high quality replacement. The benefit of our regulator is our manufacturer. They studied the faults of the original equipment manufacturer, then made changes and re-engineered to correct those faults.

Specifications

  • LH (Driver Side) REAR DOOR
  • Includes the power window motor
  • Replaces dealer part numbers: 827212Y000, 8073189909, 82721-2Y000, 80731-89909

Assembly includes regulator and motor as shown.

Window Regulator Installation Tips and FAQ.

This part makes a great replacement and has substantial cost savings over a dealer unit.

WARNING:  This product can expose you to chemicals including Lead and Lead Compounds, which are known to the State of California to cause cancer, and birth defects or other reproductive harm.  For more information, go to www.P65Warnings.ca.gov.

Please Note:

This window regulator is a high quality aftermarket part that meets or exceeds the performance of the original. It has been subjected to extensive testing and quality control standards. That is why we offer this regulator with our superior warranty!

Direct Fit

Direct fit, pre-assembled parts made ready to fit your vehicle and provide easy and trouble-free installation.

Rigorously Tested

Build to strict quality standards

Highest Quality Materials

Made from the highest quality materials for extreme durability and premium performance.

Part Details

  • Operation: Power
  • Regulator Option: with Motor

Lifetime Warranty

This item is backed by a Limited Lifetime Warranty. In the event this item should fail due to manufacturing defects during intended use, we will exchange the part free of charge (excludes shipping charges) for the original purchaser.

  1. step : Removing the Door Panel (0:45)
    • Pry off the trim piece inside the door pull with a flat blade screwdriver
    • Pry off the door handle bezel
    • Remove the Phillips head screw inside the door pull
    • Pry up the door pull and switch panel
    • Disconnect the window switch wiring harness
    • Pry out the door panel
    • Lift the door panel up and off
    • Remove the two 10mm bolts from the brace
    • Carefully peel off the water shield
  2. step : Removing the Window Regulator (3:32)
    • Loosen the two 10mm bolts that hold the window to the regulator
    • Raise the window by hand
    • Hold the window in place with painter's tape
    • Remove the four 10mm bolts from the regulator
    • Remove the three 10mm bolts from the window motor
    • Disconnect the window motor lead
    • Pull the window regulator out through the door
  3. step : Reinstalling the Regulator (6:45)
    • Insert one of the bolts into the window regulator
    • Push the regulator into the door
    • Hang the regulator by its bolt
    • Insert the four 10mm bolts into the regulator
    • Insert the three 10mm bolts into the window motor
    • Remove the painter's tape from the window
    • Lower the window onto the regulator
    • Insert the two 10mm bolts that hold the window to the regulator
    • Connect the window motor lead
    • Wire-tie the excess pigtail if there is one
  4. step : Reinstalling the Door Panel (9:03)
    • Put the water shield into place
    • Insert the two 10mm bolts to the brace
    • Lift the door panel into place
    • Push in the door panel clips
    • Connect the window switch wiring harness
    • Push in the switch panel
    • Insert the Phillips head screw inside the door pull
    • Push in the trim piece inside the door pull
    • Push on the door handle bezel

Tools needed for replacement:

    General Tools

  • Putty Knife

  • Materials, Fluids, and Supplies

  • Painter's Tape
  • Wire Ties

  • Ratchets & Related

  • Ratchet
  • Socket Extensions

  • Screwdrivers & Related

  • Phillips Head Screwdriver
  • Flat Blade Screwdriver

  • Sockets - Metric

  • 10mm Socket

  • Specialty Tools

  • Door Panel Removal Tool

There are no reviews for this item. Write Review
Start typing your question and we'll check if it was already asked and answered. Learn More
No questions have been asked about this item. Be the first!

Vehicle Fit

Year Make Model Description
2000-2001Infiniti I30 Infiniti I30 Rear Power Window Regulator with Motor Driver Side
2002-2004Infiniti I35 Infiniti I35 Rear Power Window Regulator with Motor Driver Side
2000-2003Nissan Maxima Nissan Maxima Rear Power Window Regulator with Motor Driver Side

This part replaces:

  • Partslink NI1550105
  • Hollander 617-58494L, 135-58420L
  • Dorman 741-774
  • OE # 827212Y000
  • OE # 8073189909
Part #: 1AWRG00324


Order must be placed by 4pm ET

Get it in: 2 - 4 Business Days

Want it sooner? Choose Next Day Air at Checkout

How-to Video:

(11:24 min)