Replaces

Window Regulator Pair Dorman 748-546, 748-547 - 1AWRK00821

These replacement power window regulators are just what you need to get your vehicle in good shape again!

Specifications:

  • Comes as a PAIR
    • Fits both LH (Driver Side) & RH (Passenger Side) REAR DOORS
  • Replaces dealer part numbers: 5065472AC, 5065473AC
  • Power operation
  • Includes power window motors
  • Direct replacements
  • Built to strict quality control standards

These power window regulators make great replacements and have good cost savings over dealer units.

Please Note: These window regulators are high quality aftermarket parts that meets or exceeds the performance of the original. They have been subjected to extensive testing and quality control standards. That is why we offer these regulators with our superior warranty!

Installation

  • This repair is easier than you may think. You'll find our installation videos helpful. In our experience removing and replacing the door panel is the most involved step in the repair. On most vehicles this only requires removing a few screws and push-in clips.
  • You'll get a great feeling of accomplishment after you complete this repair knowing you saved money, and you didn't have to give up your car for a day at the repair shop. Your passengers and other drivers will be amazed.

Fit guaranteed

  • 1A Auto will refund you with no hassle if this window regulator does not fit the application stated.
  • This regulator will install just as your original does. Save time and money.

Quality

  • Be confident this part will work right. Every regulator is tested after assembly to make sure all mechanisms are working correctly.
  • It is important that your new regulator works for a long period of time. The design of this regulator is tested to withstand 10,000 cycles. That is enough to raise and lower your window 3 times per day for 9 years.

Value

  • Windows that don't work can be frustrating. They can also hurt your vehicles value. An inoperable window could mean $200-$500 discounted off a dealer trade value or asking price.
  • Some shops and dealers charge more for parts and repairs when they think you don't know what is involved. Now you can get the value you deserve. Knowing what this repair entails can be the difference between the value of doing it yourself, or the pain of a costly repair bill.

Lifetime Warranty

This item is backed by a Limited Lifetime Warranty. In the event this item should fail due to manufacturing defects during intended use, we will exchange the part free of charge (excludes shipping charges) for the original purchaser. Please keep your invoice for proof of this warranty.

  1. step : Removing the Door Panel (0:50)
    • Pry out the four push pins around the panel's sides
    • Remove the Phillips head screws along the bottom of the panel
    • Pry down the trap door behind the door handle and below the door pull
    • Remove the two Phillips screws
    • Slide the panel up and off of the door lock
    • Slide the latch rod out of the door handle
    • Disconnect the window switch connector
  2. step : Removing the Window Regulator (2:36)
    • Release the water shield adhesive with a razor
    • Carefully peel off the water shield
    • Connect the window switch electrical connector
    • Roll down the window
    • If the window does not roll down with the switch, cut the regulator cables
    • Disconnect the window switch electrical connector
    • Loosen the two 10mm bolts from the window rail
    • Raise the window by hand
    • Hold the window in place with painter's tape
    • Remove the 10mm bolt at the bottom of the door pull support
    • Loosen the 10mm bolt at the top of the door pull support
    • Pull out the door pull support
    • Disconnect the window motor electrical connector
    • Remove the 10mm bolt from the front of the regulator
    • Loosen the remaining two 10mm bolts from the regulator
    • Pull the regulator out of the door
  3. step : Installing the Window Regulator (6:14)
    • Slide the regulator into the door
    • Hang the regulator by its bolts
    • Tighten the two 10mm bolts for the regulator
    • Install the 10mm bolt for the front of the regulator
    • Connect the window motor electrical connector
    • Remove the painter's tape from the window
    • Lower the window onto the rail
    • Tighten the two 10mm bolts that hold the window to the rail
    • Hang the door pull support bracket by its top bolt
    • Tighten the top door pull support bolt
    • Install the bottom door pull support bolt
    • Line up the watershield
    • Press on the water shield adhesive
    • Tape the water shield into place if necessary
  4. step : Installing the Door Panel (8:33)
    • Connect the window switch connector
    • Connect the latch rod out of the door handle
    • Slide the door panel up into place
    • Press in the door panel clips
    • Tighten the three Phillips screws to the panel
    • Close the trap doors
    • Press on the four push pins to the door panel

Tools needed for replacement:

    General Tools

  • Razor Blade / Gasket Scraper

  • Materials, Fluids, and Supplies

  • Painter's Tape

  • Ratchets & Related

  • Ratchet
  • Torque Wrench
  • Socket Extensions

  • Screwdrivers & Related

  • Phillips Head Screwdriver

  • Sockets - Metric

  • 10mm Socket

There are no reviews for this item. Write Review
Start typing your question and we'll check if it was already asked and answered. Learn More
No questions have been asked about this item. Be the first!

Vehicle Fit

  • 2005-2010 Chrysler 300 Rear Power Window Regulator with Motor Pair Dorman 748-546, 748-547
  • 2006-2010 Dodge Charger Rear Power Window Regulator with Motor Pair Dorman 748-546, 748-547
  • 2005-2008 Dodge Magnum Rear Power Window Regulator with Motor Pair Dorman 748-546, 748-547

This part replaces:

  • Dorman 748-546, 748-547
Only 3 left in stock
Part #: 1AWRK00821

Ships Same Day for orders placed by 4 P.M. ET

Dorman
Brand #: 748-546, 748-547

How-to Video:

(09:35 min)