Window Regulator Dorman 740-861 - 1AWRG00369

The original design for these manual window raising and lowering mechanisms was flawed. The original design caused the cable to break prematurely. Our window regulator has been re-engineered to correct the fault of the original design. No drilling or modifying is required.

Specifications:

• RH (Passenger Side) FRONT DOOR
• Manual operation
• Replaces dealer part number: 4675602AB
• Dual rail style
• Direct replacement
• Built to strict quality control standards

This window regulator makes a great replacement and has good cost savings over a dealer unit.

Please Note:

This window regulator is a high quality aftermarket part that meets or exceeds the performance of the original. It has been subjected to extensive testing and quality control standards. That is why we offer this regulator with our superior warranty!

Item Condition: New

Attention California Customers:

WARNING:  This product can expose you to chemicals including Chromium (Hexavalent Compounds), which is known to the State of California to cause cancer, and birth defects or other reproductive harm.  For more information, go to www.P65Warnings.ca.gov.

Lifetime Warranty

This item is backed by a Limited Lifetime Warranty. In the event this item should fail due to manufacturing defects during intended use, we will exchange the part free of charge (excludes shipping charges) for the original purchaser.

step : Remove the door panel (1:27)

• Use a window crank removal tool (which you can purchase on our website) to remove the window crank
• Remove all the Phillips screws securing the door panel.
• There should be one in your door pull, two behind/in the door handle area and one on the upper inside corner of the door panel.
• Use a putty knife or door panel removal tool (also found on our website) to unclip the door panel from the door.
• Disconnect the wiring harness connections and door latch rod.
• Carefully peel back the water shield.

step : Remove the window regulator (3:58)

• Unclip the window from the regulator with your flat blade screwdriver.
• Tape the window up with painters tape so it’s out of the way and set the wire clips aside somewhere safe.
• Unbolt the four bolts securing the rails using your T30 Torx bit and ratchet.
• Pry off the crank assembly and use pliers and a flat blade screwdriver to assist with this.

step : Install the new window regulator (8:40)

• Feed the regulator tracks up into the door and bolt them in with your T30 Torx socket and ratchet.
• Clip the crank assembly onto the door.
• Untape the window and secure it to the window regulator, using your metal clips you saved to secure it.
• Replace the water shield.

step : Install the door panel (12:56)

• Make sure all the door panel clips are transferred to the door panel.
• Connect the latch rod and clip the door panel to the door.
• Secure the four Phillips screws.
• Replace the window crank.