Replaces

Wheel Bearing & Hub Assembly Rear Pair TRQ BHA53405 - 1ASHS00134

These replacement wheel bearing & hub assemblies are just what you need to get your vehicle in good working order again.

Specifications:

  • Comes as a PAIR
    • Fits both LH (Driver Side) & RH (Passenger Side)
  • Replaces dealer part numbers: 7466992, 7467113, 7467119, 7470519, 7470520, 7470555, 7470556
  • 4 Bolt Rectangular Flange
  • Fits 5 Lug Wheel
  • Have ABS with Integral Sensors
  • Studs already installed
  • Direct replacements
  • Built to strict quality control standards
These wheel bearing & hub assemblies make great replacements and have good cost savings over dealer units.

WARNING: Cancer and Reproductive Harm - www.P65Warnings.ca.gov.

Precision Engineered

From the highest grade SAE 1055 / 65Mn high carbon steel to exact OEM design.
100% Factory tested to precise OEM tolerances.

Highest Quality Materials

High quality, multi-lip seal reduces the intrusion of dirt and water. Heavy duty grease resists high temperature, moisture, and reduces intense friction.

Direct Fit Replacement

Guaranteed to fit and function correctly for your specific application.

Part Details

  • Front or Rear Location: Rear
  • Quantity: Pair
  • Bearing Type: Ball Bearing

Lifetime Warranty

This item is backed by a Limited Lifetime Warranty. In the event this item should fail due to manufacturing defects during intended use, we will exchange the part free of charge (excludes shipping charges) for the original purchaser.

  1. step : Removing the Wheel (0:50)
    • Pry off the center cap by hand
    • Loosen the lug nuts with the vehicle on the ground
    • Raise the vehicle with a floor jack
    • Secure the vehicle on jack stands
    • Remove the lug nuts
    • Pull off the wheel
  2. step : Removing the Brake Pads (1:13)
    • Remove the 12mm bolt from the brake caliper
    • Remove the 13mm bolt from the bracket
    • Pry the brake pads out with a flat blade screwdriver to push the caliper pistons in
    • Pull the caliper aside
    • Remove the brake pads
  3. step : Removing the Brake Rotor (2:26)
    • Remove the two 15mm bolts from the brake caliper bracket
    • Pull off the brake caliper bracket
    • Pull the rotor off
    • If the rotor will not come off, strike the center of the rotor with a hammer to loosen it
  4. step : Removing the Wheel Hub (4:23)
    • Disconnect the ABS sensor wiring harness
    • Remove the four 13mm bolts from the hub
    • Strike the hub with a hammer to loosen
    • Pull off the hub
    • Pull of the brake backing plate
    • Clean the hub mounting area with a wire brush
  5. step : Installing the New Wheel Hub (5:57)
    • Hold the backing plate in place with the open end facing the front of the vehicle
    • Put the hub into place with the ABS sensor connector facing the front of the vehicle
    • Start one bolt into the hub
    • Start the other three bolts
    • Tighten the three 13mm bolts into the hub to 60 foot-pounds of torque
    • Connect the ABS sensor wiring harness
  6. step : Installing the New Brake Rotor (7:36)
    • Slide the rotor on
    • Thread one lug nut to hold the rotor in place
    • Put the caliperbracket back into place
    • Start the two 15mm bolts by hand
    • Tighten the bolts to 60 foot-pounds of torque
  7. step : Installing the New Brake Pads (9:21)
    • Install the new brake pads into the caliper bracket
    • Put the caliper on
    • Thread the 12mm bolt by hand
    • Tighten the 12mm bolt to between 12 – 15 foot-pounds
    • Insert the 13mm bolt into the bracket
    • Remove the placeholder lug nut
  8. step : Reattaching the Wheel (10:08)
    • Slide the wheel into place
    • Start the lug nuts by hand
    • Tighten the lug nuts preliminarily
    • Lower the vehicle to the ground
    • Tighten the lug nuts to 100 foot-pounds in a crossing or star pattern
    • Reattach the center cap
  9. step : Testing the Brakes (10:35)
    • Pump your brakes repeatedly until they feel firm
    • Test your brakes at 5 miles per hour and then 10 miles per hour
    • Road test the vehicle

Tools needed for replacement:

    General Tools

  • Hammer
  • Jack Stands
  • Floor Jack
  • Wire Brush

  • Ratchets & Related

  • Socket Extensions
  • A Piece of Pipe (for leverage)
  • Ratchet
  • 1/2 Inch Breaker Bar
  • Torque Wrench

  • Screwdrivers & Related

  • Flat Blade Screwdriver

  • Sockets - Metric

  • 15mm Socket
  • 12mm Socket
  • 19mm Socket
  • 13mm Socket

  • Wrenches - Metric

  • 15mm Wrench

5.0 / 5.0
1 Review
5 Stars
4 Stars
3 Stars
2 Stars
1 Star
1
0
0
0
0
hub and bearing assy.
great company to deal with and great prices thanks.
December 12, 2017
Purchased
10 months ago
Start typing your question and we'll check if it was already asked and answered. Learn More
Browse 2 questions Browse 2 questions and 4 answers
What brand are these bearings are they brand new?
Chill on Nov 3, 2017
BEST ANSWER: There were no names on the boxes as I recall. The bearings are brand new mine have been installed over a year with no problemsEnter an answer to this question.
Does these fit the front,06 cadillac dts?
Ty T on Sep 16, 2018
BEST ANSWER: This part is specific to vehicles with a particular set of options. We will need more information about your vehicle to confirm the fit.

Vehicle Fit

Year Make Model Description
2000-2005Buick LeSabre Buick LeSabre Rear Wheel Bearing & Hub Assembly Pair TRQ
2006-2011Buick Lucerne Buick Lucerne Rear Wheel Bearing & Hub Assembly Pair TRQ
1997-2005Buick Park Avenue Buick Park Avenue Rear Wheel Bearing & Hub Assembly Pair TRQ
1991Buick Reatta Buick Reatta Rear Wheel Bearing & Hub Assembly Pair TRQ
1991-1993Buick Riviera Buick Riviera Rear Wheel Bearing & Hub Assembly Pair TRQ
1995-1999Buick Riviera Buick Riviera Rear Wheel Bearing & Hub Assembly Pair TRQ
1991-1992Cadillac Allante Cadillac Allante Rear Wheel Bearing & Hub Assembly Pair TRQ
2006-2011Cadillac DTS Cadillac DTS Rear Wheel Bearing & Hub Assembly Pair for Models with RPO Code JL9 (Power 4 Wheel ABS Disc Brakes) TRQ
2000-2005Cadillac Deville Cadillac Deville Rear Wheel Bearing & Hub Assembly for Models with ABS Brakes Pair TRQ
1991-1992Cadillac Eldorado Cadillac Eldorado Rear Wheel Bearing & Hub Assembly Pair TRQ
1991-1992Cadillac Seville Cadillac Seville Rear Wheel Bearing & Hub Assembly Pair TRQ
1997-2000Chevy Malibu Chevy Malibu Rear Wheel Bearing & Hub Assembly Pair TRQ
1995-2003Oldsmobile Aurora Olds Aurora Rear Wheel Bearing & Hub Assembly Pair TRQ
1997Oldsmobile Cutlass Olds Cutlass Rear Wheel Bearing & Hub Assembly Pair (excluding Supreme Models) TRQ
1998-1999Oldsmobile Cutlass Olds Cutlass Rear Wheel Bearing & Hub Assembly Pair TRQ
1991-1992Oldsmobile Toronado Olds Toronado Rear Wheel Bearing & Hub Assembly Pair TRQ
2000-2005Pontiac Bonneville Pontiac Bonneville Rear Wheel Bearing & Hub Assembly Pair TRQ
1999-2000Pontiac Grand Am Pontiac Grand Am SE Rear Wheel Bearing & Hub Assembly Pair TRQ

This part replaces:

  • TRQ BHA53405
Part #: 1ASHS00134


Order must be placed by 4pm ET

Get it in: 2 - 4 Business Days

Want it sooner? Choose Next Day Air at Checkout

TRQ
Brand #: BHA53405

How-to Video:

(11:09 min)