Lifetime Warranty

This item is backed by a Limited Lifetime Warranty. In the event this item should fail due to manufacturing defects during intended use, we will exchange the part free of charge (excludes shipping charges) for the original purchaser. Please keep your invoice for proof of this warranty.

  1. step : Removing the Wheel (0:59)
    • Remove the center cap.
    • Loosen the lug nuts.
    • Raise the vehicle and remove the lug nuts.
    • Pull the wheel off.
  2. step : Removing the Hub (1:15)
    • Use a ratchet and a piece of pipe for leverage to remove the CV 34mm nut.
    • Use the 3/8â€� Allen tool to remove the two bolts on the back of the caliper.
    • Pry the caliper up to separate it from the rotor.
    • Disconnect the connector behind the hub.
    • Hammer the axel in to make sure it’s free from the hub.
    • Rotate the hub to locate the T55 bolts. Remove two and loosen one.
    • Hit the back side of the hub until it breaks free.
    • Remove the bolt and pull the hub free.
  3. step : Preparing the Area (4:27)
    • Use a wire brush to clean where the hub fits into.
    • Scrape rust off with a flat blade screwdriver or a chisel so the hub will sit flush up against it.
  4. step : Reassembling the Hub (4:54)
    • Push the hub into place and replace the backing plate.
    • Reinstall the T55 bolts and torque them to 55ft/lbs.
    • Reconnect the connector and clip it to the backing plate.
    • Reinstall the 34mm nut.
    • Put the rotor back into place.
    • Put the pads into place.
    • Slide the caliper back on to the rotor.
    • Replace and tighten the Allen bolts.
  5. step : Replacing the Wheel (6:58)
    • Replace the wheel.
    • Replace the lug nuts.
    • Lower the vehicle and torque the lug nuts to 100ft/lbs.
    • Tighten the CV nut to 107ft/lbs.
    • Replace the center cap.
    • Pump the brakes until they get firm.

Tools needed for replacement:

    Allen Wrenches

  • 3/8 Inch Allen Wrench

  • General Tools

  • Hammer
  • Wire Brush
  • Jack Stands

  • Ratchets & Related

  • A Piece of Pipe (for leverage)
  • Torque Wrench
  • Ratchet

  • Screwdrivers & Related

  • Pry Bar

  • Sockets - Metric

  • 19mm Socket
  • 34mm Socket

  • Torx Drivers & Sockets

  • T55 Torx Socket

There are no reviews for this item. Write Review
Start typing your question and we'll check if it was already asked and answered. Learn More
No questions have been asked about this item. Be the first!

How-to Video:

(07:55 min)

Tools List:

    Allen Wrenches

  • 3/8 Inch Allen Wrench

  • General Tools

  • Hammer
  • Wire Brush
  • Jack Stands

  • Ratchets & Related

  • A Piece of Pipe (for leverage)
  • Torque Wrench
  • Ratchet

  • Screwdrivers & Related

  • Pry Bar

  • Sockets - Metric

  • 19mm Socket
  • 34mm Socket

  • Torx Drivers & Sockets

  • T55 Torx Socket



This part replaces:

  • TRQ BHA84976

Vehicle Fit

  • 1994-1996 Buick Century (1) 34mm Axle Nut Socket Wheel Bearing & Hub Assembly Front with
  • 1992 Buick LeSabre with ABS Brakes Wheel Bearing & Hub Assembly Front with (1) 34mm Axle Nut Socket
  • 1993-1999 Buick LeSabre (1) 34mm Axle Nut Socket Wheel Bearing & Hub Assembly Front with
  • 1992-1996 Buick Park Avenue (1) 34mm Axle Nut Socket Wheel Bearing & Hub Assembly Front with
  • 1992-1996 Buick Riviera (1) 34mm Axle Nut Socket Wheel Bearing & Hub Assembly Front with
  • 1993 Cadillac Allante (1) 34mm Axle Nut Socket Wheel Bearing & Hub Assembly Front with
  • 1992-1993 Cadillac Deville with ABS Brakes Wheel Bearing & Hub Assembly Front with (1) 34mm Axle Nut Socket
  • 1994-1996 Cadillac Deville (1) 34mm Axle Nut Socket Wheel Bearing & Hub Assembly Front with
  • 1992-1996 Cadillac Eldorado (1) 34mm Axle Nut Socket Wheel Bearing & Hub Assembly Front with
  • 1992-1993 Cadillac Fleetwood Front Wheel Drive with ABS Brakes Wheel Bearing & Hub Assembly Front with (1) 34mm Axle Nut Socket
  • 1992-1994 Chevy Lumina APV 16.25mm Lug Hole Wheel Bearing & Hub Assembly Front with (1) 34mm Axle Nut Socket
  • 1995-1996 Chevy Lumina APV (1) 34mm Axle Nut Socket Wheel Bearing & Hub Assembly Front with
  • 1992 Olds 88 with ABS Brakes Wheel Bearing & Hub Assembly Front with (1) 34mm Axle Nut Socket
  • 1993-1999 Olds 88 (1) 34mm Axle Nut Socket Wheel Bearing & Hub Assembly Front with
  • 1992 Olds 98 with ABS Brakes Wheel Bearing & Hub Assembly Front with (1) 34mm Axle Nut Socket
  • 1992 Olds 98-Regency with ABS Brakes Wheel Bearing & Hub Assembly Front with (1) 34mm Axle Nut Socket
  • 1995-1996 Olds Aurora (1) 34mm Axle Nut Socket Wheel Bearing & Hub Assembly Front with
  • 1994-1996 Olds Cutlass Ciera (1) 34mm Axle Nut Socket Wheel Bearing & Hub Assembly Front with
  • 1992 Olds Delta 88 with ABS Brakes Wheel Bearing & Hub Assembly Front with (1) 34mm Axle Nut Socket
  • 1993-1999 Olds Delta 88 (1) 34mm Axle Nut Socket Wheel Bearing & Hub Assembly Front with
  • 1992 Olds Delta 88-Royale with ABS Brakes Wheel Bearing & Hub Assembly Front with (1) 34mm Axle Nut Socket
  • 1993-1999 Olds Delta 88-Royale (1) 34mm Axle Nut Socket Wheel Bearing & Hub Assembly Front with
  • 1992 Pontiac Bonneville with ABS Brakes Wheel Bearing & Hub Assembly Front with (1) 34mm Axle Nut Socket
  • 1993-1999 Pontiac Bonneville (1) 34mm Axle Nut Socket Wheel Bearing & Hub Assembly Front with
Only 4 left in stock
Part #: 1ASHS01178

Ships Same Day for orders placed by 4 P.M. ET

We're here to help

1A Auto Parts

Customer Feedback

"Thanks for the fast reliable service. Great price, and the headlights were as good as oem or better!!! Keep up the good work..."
- Dwuan M.
Read More