VW Beetle Golf Jetta Steering & Suspension Kit 6 Piece Set TRQ PSA58660

Frequently bought together

Vehicle Fit
Warranty & Shipping
How-To & Tools

Part Details

  • Quantity:   6 Piece Set
  • Kit Includes:
      (2) Front Lower Ball Joints
      (2) Front Lower Control Arms
      (2) Front Inner & Outer Tie Rod Assemblies


  • Brand New Steering & Suspension Kit
  • Comes as a 6 Piece Kit
    • Fits LH (Driver Side) & RH (Passenger Side)
  • Direct replacements
  • Built to strict quality control standards

Our steering and suspension components come pre-greased, sealed for long life, and do not require the extra maintenance typically required by greasable versions.

Direct Fit

Application-specific, with no modifications required.

Rigorously Tested

Made from higher quality materials than the competition. Built to have a longer life in any environment or road conditions.

State of the Art Manufacturing

By the same factories that the OEMs use.

Prepackaged for Your Convenience

Carefully assembled to include all of the parts you need, saving time and money.

Item Condition: New

Attention California Customers:

WARNING:  This product can expose you to chemicals including Chromium (Hexavalent Compounds), which is known to the State of California to cause cancer, and birth defects or other reproductive harm.  For more information, go to

Lifetime Warranty

This item is backed by our limited lifetime warranty. In the event this item should fail due to manufacturing defects during intended use, we will replace the part free of charge.

Note: When replacing steering components, it is recommended to have a professional alignment performed on the vehicle afterwards. This will ensure proper tracking and even tire wear.

  1. step : Removing the Wheel (0:44)
    • Remove the lug nut covers with a 7mm Allen bit
    • Push the lug nut key into the special lug nut
    • Loosen the lug nuts with the vehicle on the ground
    • Raise the vehicle with a floor jack
    • Secure the vehicle on jack stands
    • Remove the lug nuts
    • Pull off the wheel
  2. step : Removing the Lower Control Arm (1:37)
    • Remove the first 18mm bolt from the control arm with a ratchet and pipe for leverage
    • Loosen the second 18mm bolt with the ratchet and pipe
    • Hold the bolt with an 18mm wrench
    • Remove the second 18mm bolt with the ratchet
    • Remove the 16mm bolt from the sway bar link
    • Attach locking pliers between the wheel knuckle and the ball joint nut
    • Remove the ball joint nut with a 19mm wrench
    • Pull the wheel aside
    • Pull the control arm down and out
  3. step : Removing the Ball Joint from the Control Arm (3:20)
    • Remove the three 13mm bolts that hold the ball joint in place
    • Pull the ball joint out of the control arm
  4. step : Attaching the Ball Joint to the New Control Arm (3:33)
    • Put the new ball joint into place on the control arm
    • Put the ball joint bracket into place
    • Thread the 13mm bolts through from the bottom
    • Tighten the 13mm bolts to 40 foot-pounds of torque
  5. step : Installing the Lower Control Arm (4:10)
    • Push the control arm into place
    • Tap it into place with a hammer if necessary
    • Push the 18mm bolts and associated nuts into place
    • Push the ball joint into the wheel knuckle
    • Put the 19mm nut onto the ball joint
    • Tighten the 19mm nut
    • Tighten the 18mm bolts to 70 foot-pounds
    • Insert the 16mm bolt into the sway bar link
  6. step : Reattaching the Wheel (6:08)
    • Slide the wheel into place
    • Start the lug nuts by hand
    • Tighten the lug nuts preliminarily
    • Lower the vehicle to the ground
    • Tighten the lug nuts to 100 foot-pounds in a crossing or star pattern
    • Reattach the lug nut caps

Tools needed for replacement:

    General Tools

  • Jack Stands
  • Floor Jack
  • Hammer

  • Hex Wrenches

  • 7mm Allen Wrench

  • Pliers, Cutters & misc Wrenches

  • Vise Grip Pliers

  • Sockets - Metric

  • 17mm Socket
  • 16mm Socket
  • 18mm Socket

  • Wrenches - Metric

  • 13mm Wrench
  • 19mm Wrench
  • 18mm Wrench

Customer Q&A
Ask a question to 1A Auto customers who purchased the product
Do I need to buy the control arm bushings as well as this product?
Katie A September 15, 2015
No, this kit came with everything needed for the control arm. I installed this kit on my car. Just a little extra note on this install: The only issue I came across was not the parts, but with the car... All YouTube DIY videos show the installation on the passenger side... Well, that is because the driver side SUCKS. The ATF pan is in the way of the front bolt on the arm. I had to remove three subframe bolts and jack the engine up to provide enough clearance to remove the bolt to take the old arm off and reinstall the new one. P.S. The passenger side is a breeze.
Kimberly S September 15, 2015
No you dont need too everything you need comes with the set
Jeffrey M September 15, 2015
You should not have to. The control arms I got had the bushings already installed as is shown in the photo. Good luck!
Paul M September 15, 2015
No. They are included and pressed in, ready to go on the control arms.
Frank F September 15, 2015
Hello Katie if you are thinking to remplace your struts and shocks you can get A arms set is more better and the price is perfect and easy to instal.l
Jaime J September 15, 2015
This product has the bushing already pressed inside of the control arm.
Darlyn S September 16, 2015
What are the grease packets for that came with the ball joints?
Kolar C January 18, 2017
Hello Kolar. Thank you for your inquiry, but these ball joints are prepacked with grease, and are sealed units. These do not have grease fittings, so they are not serviceable.
Tim K January 19, 2017
Are the control arms the same style for driver and passenger side?
Mike M July 3, 2017
Yes theyre the same you just attach the end attaching bolt thingy to match whichever side. Piece of cake to do.
Mark F July 3, 2017
Yes, exactly the same. The way you install the ball joints is the only difference, Mike. Hope that helps.
James J July 3, 2017
Yes they are the same... its a easy simple fix. That will save you a lot of money!
Leonel A July 3, 2017

Fits the following Makes:

Year Make Model Description
1998Volkswagen Beetle VW Beetle (Built After 6/98 Production Date) Steering & Suspension Kit 6 Piece Set
1999-2010Volkswagen Beetle VW Beetle Steering & Suspension Kit 6 Piece Set
1999Volkswagen Golf VW Golf (8th Vin Digit J) (Built After 10/98 Production Date) Steering & Suspension Kit 6 Piece Set
2000-2006Volkswagen Golf VW Golf Steering & Suspension Kit 6 Piece Set
1999Volkswagen Jetta VW Jetta (8th Vin Digit M) (Built After 10/98 Production Date) Steering & Suspension Kit 6 Piece Set
2000-2004Volkswagen Jetta VW Jetta Steering & Suspension Kit 6 Piece Set
2005Volkswagen Jetta VW Jetta (8th Vin Digit J or M) (Built Before 12/30/04 Production Date) Steering & Suspension Kit 6 Piece Set

Part Interchange

Brand Label Part Number
Beck / Arnley 102-5884
Beck/Arnley 102-5884
Delphi TC2010
Dorman - OE Solutions 520-760
Dorman OE Solutions 520-760
Ingalls Engineering CAK640176
MAS Industries CA43095
MAS Industries CA43095PR
MOOG K90357
MOOG RK620718
MOOG CK640176
MOOG RK640176
MOOG K90355
MOOG RK620717
MOOG K640176
MOOG Chassis Products K640176
MOOG Chassis Products K90355
MOOG Chassis Products K90357
MOOG Chassis Products RK620717
MOOG Chassis Products RK620718
MOOG Chassis Products RK640176
MOOG Chassis Products CK640176
MOOG Chassis Products ES3709A
MOOG Chassis Products ES3710A
MasterPro 5CB70115
Mcquay-Norris FA4333
Mevotech MS20475
Mevotech CMS701121
Mevotech GS20475
Mevotech CMS20475
NAPA Premium 2605459
NAPA Premium 2607188
NAPA Premium 2605460
Precision Driveline 5CB70019
Precision Driveline CB70019
Raybestos Chassis 507-1247
SYD 1J0407151
Volkswagen 1J0407151B
Volkswagen 1J0407151C

This item may be interchangeable with parts from other brands with the above part numbers. This information is provided only for reference and does not guarantee that the item you are purchasing is identical to parts with part numbers from the brands listed above. To confirm that this item fits your vehicle, use the above "Check Vehicle Fit" option.

Part 1ASFK00419
In Stock

Orders must be placed by 2pm ET
Delivery options for:

Estimated Arrival Cost

Deliveries made to PO Boxes and FPO may take longer. See our Shipping & Delivery for more information.

Brand #: PSA58660