Specifications

  • Fits LH (Driver Side)
  • Includes lens and housing
  • Bulbs not included
  • Correct for Vehicles with VIN ending in 050000 and Higher
  • Fits models with Halogen Style Headlights
    • Does NOT fit models with HID (High Intensity Display) Headlights
This headlight is a great replacement and has good cost savings over a head light from the dealer.
Fit guaranteed
  • This headlamp will install just as your original does. You can use your existing hardware and wiring harnesses.
  • Save time and money with a direct fit. No trips to the hardware store or extra time trying to get the wiring to hookup.
Quality
  • 1A Auto has the most comprehensive warranty.
  • If this headlight should fail to provide satisfactory performance you may exchange it.
  • 1A Auto Headlights are guaranteed to pass inspections in all 50 states. DOT (U.S. Dept. of Transportation) and SAE (Society of Automotive Engineers) approved.
Value
  • Replacing a discolored, scratched, dull or damaged headlight with a headlight from 1A Auto can increase your resale value by up to 10%.
Safety
  • A new headlight can provide you with up to 50% more illumination than a dull, yellowed, sandblasted, broken or scratched headlight.
    • 1A Auto headlights can help you see farther at night and in poor driving conditions.
    • A new headlight from 1A Auto can make you more visible to other traffic during heavy rain or wintry weather.
Direct Fit Replacement

Direct fit replacement for OEM assembly

Trouble-free Installation

Light uses same wiring as the original assembly, providing easy, trouble-free installation.  No cutting or splicing required.

DOT and SAE Compliant

DOT & SAE compliant: meets federal regulations for on-road use

Lifetime Warranty

This item is backed by a Limited Lifetime Warranty. In the event this item should fail due to manufacturing defects during intended use, we will exchange the part free of charge (excludes shipping charges) for the original purchaser. Please keep your invoice for proof of this warranty.

Bulb Note:

Unless otherwise noted, our lights do not include bulbs, though occasionally lighting manufacturers do include bulbs in the lights. If you happen to receive a lighting product (Headlight, Tail light, parking light, fog light etc.) that comes with the bulbs, the bulbs are not covered under our warranty. Our warranty applies only to the light assembly.

    Note: DO NOT TOUCH the bulbs- the oil from your fingers will burn into the light and foul your bulb. Clean with rubbing alcohol and a soft cloth if the bulbs do get touched.

  1. step : To replace just the headlight bulbs (1:00)
    • Pop the hood and secure it.
    • Drivers side: Unclip the plastic cover to access the back of the headlight assembly.
    • Passenger side: Remove the three screws securing the duct behind the headlight assembly.
    • Reach behind the headlight assembly.
    • Pull aside the rubber boot and unclip the retaining wire.
    • Remove and replace the bulb.
    • Anchor it with the retaining wire and seal it in with the rubber boot.
  2. step : Remove the bumper cover (2:45)
    • Remove the seven T25 screws and 3 flat blade clips
    • Use a flat blade screwdriver to pry out the side marker lights
    • Remove the two T30 screws on the top of the grille
    • Use a screwdriver to pry the metal hood release handle out.
    • Pull the grille straight up and off.
    • Remove the four T30 screws exposed.
    • Pull off the front bumper cover
    • Unplug your fog lights.
    • Set the fascia aside.
  3. step : Remove the head light assembly (6:52)
    • Remove the two T30 bolts on the panel below and to the side of the headlight assembly.
    • Remove the four screws securing the headlight assembly.
    • Use an extension to access them all.
    • Disconnect the wiring harness.
    • Pull the headlight assembly out.
  4. step : Install the new headlight assembly (8:30)
    • Remove the wire ties from the new headlight assembly.
    • Plug in the wiring harness.
    • Bolt the assembly back in.
    • Secure the panel below the head light assembly and reassemble the duct if you had to remove it.
  5. step : Re-install the bumper cover (10:30)
    • Reconnect the fog lights and thread through the marker light harnesses.
    • Bolt the bumper cover back on.
    • Clip the grille back on and screw in the screws.

Tools needed for replacement:

    Ratchets & Related

  • Ratchet
  • Socket Extensions

  • Screwdrivers & Related

  • Flat Blade Screwdriver
  • Phillips Head Screwdriver

  • Sockets - Metric

  • 10mm Socket
  • 8mm Socket

  • Torx Drivers & Sockets

  • T25 Torx Driver
  • T30 Torx Driver

2.0 / 5.0
1 Review
5 Stars
4 Stars
3 Stars
2 Stars
1 Stars
0
0
0
1
0
Almost great
I ordered both headlights for my passat. I received two headlights and installed them. After installation, I looked at the front of my car and the headlights had two different lenses in them. I checked the boxes and they were from two different warehouses and two different manufacturers. I gave this two stars because individually, both looked nice. Minus three for not matching.
October 15, 2016
Start typing your question and we'll check if it was already asked and answered. Learn More
No questions have been asked about this item. Be the first!

Vehicle Fit

  • 2001 VW Passat (From VIN 050000) Halogen Headlight Driver Side
  • 2002-2005 VW Passat Halogen Headlight Driver Side

This part replaces:

  • Partslink VW2502118
  • Hollander 114-59119L
  • OE # 3B0 941 015 AQ
  • TYC 20-6244-00-1
  • DEPO 341-1109L-AF
Part #: 1ALHL00874


How-to Video:

(15:16 min)