This replacement mirror is just what you need to get your vehicle in good looking form again!

Specifications:

  • RH (Passenger Side)
  • Power operation
  • Heated
  • Turn Signal
  • Paint To Match Finish
    • Can be painted to match by buyer or installed as is
  • Folding - manual operation
  • Injection molded plastic housing
  • Replaces dealer part numbers: 1K1 857 508 CN 9B9, 1K1857508CN9B9
  • Direct replacement
  • Built to strict quality control standards

This mirror assembly makes a great replacement and has substantial cost savings over a dealer unit.

Paint To Match Note:

"Paint to match finish" refers to a smooth, paintable surface. This item will be shipped unpainted but will be ready for paint. Final preparation is suggested for better paint coverage and adhesion. 

This part can also be installed without painting if desired. 

Special Note:

  • This mirror will only work properly on vehicles with these exact options. If your vehicle does not have the options listed in specifications, the mirror may not function properly.

Part Details

  • Mirror Folding Type: Manual-Folding
  • Mirror Signal Type: Turn Signal
  • Mirror Heating Type: Heated
  • Mirror Color / Finish: Smooth Gray - Paint to Match
  • Mirror Operation: Power

Lifetime Warranty

This item is backed by a Limited Lifetime Warranty. In the event this item should fail due to manufacturing defects during intended use, we will exchange the part free of charge (excludes shipping charges) for the original purchaser.

  1. step : Removing the Interior Door Panel (0:41)
    • Pry up the window switch panel with a flat blade screwdriver
    • For the passenger side, pull out the pull handle
    • Remove the inner handle
    • Remove the two T30 Torx screws behind the inner handle
    • Remove the three T20 Torx screws on the bottom of the panel
    • Remove the T20 Torx screw at the front top corner of the door panel
    • Pry out the door panel
    • Lift the door panel up and off
    • Disconnect the latch cable from the door handle
    • Disconnect the speaker wiring lead
    • Disconnect the trunk switch wiring harness
  2. step : Removing the Mirror (2:46)
    • Remove the T20 screw from the mirror base trim panel
    • Pull off the mirror base trim panel
    • Pry the cap out of the mirror base with a flat blade screwdriver
    • Pull off the mirror base trim panel
    • Remove the three T30 screws from the mirror
    • Disconnect the mirror wiring harness
    • Unclip the mirror wiring from the door
    • Pull off the mirror
  3. step : Installing the Mirror (4:30)
    • Paint the mirror cap to the desired color
    • Feed the mirror into place
    • Insert the three T30 screws into the mirror
    • Clip the mirror wiring into the door
    • Connect the mirror wiring harness
    • Push the cap into the mirror base
    • Push on the mirror base trim panel
    • Inset the T20 screw into the mirror base trim panel
    • If you are reusing the mirror cap, pry it off the old mirror with a flat blade screwdriver
    • Slide the mirror cap onto the mirror
    • Connect the defrost wires to the mirror glass
    • Push the mirror glass onto the mirror
  4. step : Reinstalling the Interior Door Panel (9:41)
    • Connect the trunk switch wiring harness
    • Connect the speaker wiring lead
    • Connect the latch cables to the door handle
    • Lift the door panel into place
    • Push in the door panel clips
    • Insert the T30 screws into the door panel bracket
    • Insert the T20 screw at the top front corner of the door panel
    • Insert the three T20 screws at the bottom of the door panel
    • Slide the interior door handle into place
    • Push the switch panel in place

Tools needed for replacement:

    General Tools

  • Magnet - Extendable

  • Screwdrivers & Related

  • Flat Blade Screwdriver

  • Torx Drivers & Sockets

  • T20 Torx Driver
  • T30 Torx Bit

5.0 / 5.0
1 Review
5 Stars
4 Stars
3 Stars
2 Stars
1 Star
1
0
0
0
0
Perfect fit, finish, and instructions.
Mirror install took less than an hour. Didn't have to use the cap as I had already purchased a set of aftermarket Aluminum ones to use instead. It looked to be a quality part, too, though. Everything hooked right up and works as advertised. Hopefully the wife keeps this one from hi-fiving the garage door opening this time around.
March 14, 2017
Purchased
1 year ago
Start typing your question and we'll check if it was already asked and answered. Learn More
No questions have been asked about this item. Be the first!

Vehicle Fit

  • 2007-2009 VW GTI (8th Vin Digit K) Power Heated Turn Signal Manual-Folding Smooth Gray - Paint to Match Mirror Passenger Side
  • 2006 VW Golf (8th Vin Digit K) Power Heated Turn Signal Manual-Folding Smooth Gray - Paint to Match Mirror Passenger Side
  • 2007-2009 VW Golf (8th Vin Digit K) Power Heated Turn Signal Manual-Folding Smooth Gray - Paint to Match Mirror Passenger Side
  • 2008 VW Golf (8th Vin Digit K) Power Heated Turn Signal Manual-Folding Smooth Gray - Paint to Match Mirror Passenger Side
  • 2008 VW R32 (8th Vin Digit K) Power Heated Turn Signal Manual-Folding Smooth Gray - Paint to Match Mirror Passenger Side
  • 2006-2009 VW Rabbit Power Heated Turn Signal Manual-Folding Smooth Gray - Paint to Match Mirror Passenger Side

This part replaces:

  • Hollander 128-61645R, 128-51154R
  • OE # 1K1 857 508 CN 9B9
  • TYC 8610341
Part #: 1AMRE02148

How-to Video:

(11:29 min)