Replaces
Volkswagen Golf Jetta Rabbit Radiator Cooling Fan Assembly - 1ARFA00461
1ARFA00461Our aftermarket radiator fan assemblies are some of the highest quality replacements on the market! This radiator cooling fan assembly is a complete, ready to bolt on, direct replacement part.
Specifications:
- Temic Style, Single Shroud, Dual Fan
- New, not rebuilt, electric motors
- Geometrically designed plastic blade for optimal circulation and uniform balance
- 100% Performance factory tested
- Replaces original assemblies that are melted or worn out
- Comes with proper plug(s) for trouble free installation
Now you can buy a high quality radiator cooling fan motor assembly that is built to strict quality control standards. This cooling motor assembly makes a great replacement and has substantial cost savings over a dealer fan assembly.
Our electrical and electronic parts are subject to strict quality control testing. Once the item has been installed or plugged in, it is no longer eligible for a refund. The item may be eligible for replacement, only if it is found to have a manufacturing defect. Before purchasing, please ensure proper diagnosis of the failed original part is performed
Lifetime Warranty
This item is backed by a Limited Lifetime Warranty. In the event this item should fail due to manufacturing defects during intended use, we will exchange the part free of charge (excludes shipping charges) for the original purchaser. Please keep your invoice for proof of this warranty.
-
step : Removing the Splash Shield (0:35)
- Remove the T25 Torx screws from the splash shield
- Release the splash shield tabs
- Pull the splash shield down and off
-
step : Removing the Radiator Fan (1:03)
- Unclip the radiator hose from the radiator fan
- Unclip the wiring harness from the fan
- Disconnect the radiator fan wiring harness
- Remove the two T30 screws from the top of the fan
- Remove the two T30 screws from the bottom of the fan
- Pull the fan down and out
-
step : Preparing the Radiator Fan (2:29)
- Unclip the wiring harness brackets from the old fan
- Clip the brackets onto the new fan
-
step : Installing the Fan (3:22)
- Lift the fan into place
- Insert the two T30 screws into the bottom of the fan
- Connect the fan wiring harness
- Clip the harness into place
- Clip the radiator hose onto the fan
- Insert the two T30 screws into the top of the fan
-
step : Installing the Splash Shield (4:52)
- Clip on the splash shield
- Insert the T25 screws into the splash shield
Tools needed for replacement:
- Floor Jack
- Jack Stands
- Needle nose pliers
- T30 Torx Bit
- T25 Torx Driver
General Tools
Pliers, Cutters & misc Wrenches
Torx Drivers & Sockets
- Was this review helpful? Yes (2) No (0)
- Flag as Inappropriate
- Was this review helpful? Yes (2) No (0)
- Flag as Inappropriate
If you need this part get here. Delivery time better than quoted..
Will shop with these guys some more in the future..
- Was this review helpful? Yes (0) No (0)
- Flag as Inappropriate
- Was this review helpful? Yes (0) No (0)
- Flag as Inappropriate
- Was this review helpful? Yes (0) No (0)
- Flag as Inappropriate
- Was this review helpful? Yes (0) No (0)
- Flag as Inappropriate
- Was this review helpful? Yes (0) No (0)
- Flag as Inappropriate
- Was this review helpful? Yes (0) No (0)
- Flag as Inappropriate
- Was this review helpful? Yes (0) No (0)
- Flag as Inappropriate
- Was this review helpful? Yes (0) No (0)
- Flag as Inappropriate
- Was this review helpful? Yes (0) No (0)
- Flag as Inappropriate
- Was this review helpful? Yes (0) No (0)
- Flag as Inappropriate
- Was this review helpful? Yes (0) No (0)
- Flag as Inappropriate
- Was this review helpful? Yes (0) No (0)
- Flag as Inappropriate
- Was this review helpful? Yes (0) No (0)
- Flag as Inappropriate
- Was this review helpful? Yes (0) No (0)
- Flag as Inappropriate
- Reply
- Inaccurate
- Joel B on Aug 14, 2015
- Purchased on Dec 12, 2014
2006 VW Jetta Radiator Cooling Fan Assembly L5 2.5L For Models With 150 Watt Cooling Fans
- Reply
- Inaccurate
- Tim K Staff on Sep 3, 2017
- Reply
- Inaccurate
- Roberto C on Apr 27, 2017
- Purchased on May 14, 2015
Vehicle Fit
- 2010-2013 VW Golf Radiator Cooling Fan Assembly L5 2.5L for Models with 150 Watt Cooling Fans
- 2005-2007 VW Jetta Radiator Cooling Fan Assembly L5 2.5L for Models with 150 Watt Cooling Fans
- 2006-2009 VW Rabbit Radiator Cooling Fan Assembly L5 2.5L for Models with 150 Watt Cooling Fans
This part replaces:
- OE # 1K0959455DT
- OE # 1K0959455DH
- OE # 1K0959455P
- Partslink VW3120100
- Hollander 674-50213B
- TYC 621490
- DEPO 341-55005-100