Volkswagen Golf Jetta Ignition Coil - 1AECI00195

Specifications:

• New not remanufactured
• Built to strict quality control standards
• Direct replacement
• Mounts on engine head
• 100% factory tested

Note: For vehicles requiring Engine ID (Identification): The Engine ID is usually located on a paper tag located on the valve cover.

Our electrical and electronic parts are subject to strict quality control testing. Please ensure proper diagnosis of this item before purchasing as the item cannot be returned once installed or plugged in.

Guaranteed to fit and function properly for your specific application.

Meets or exceeds requirements of the vehicle. Provides the correct primary and secondary resistance, voltage output, and spark energy needed to restore original operating condition.

Manufactured with quality materials to meet highest quality control standards in the industry.

Item Condition: New

Attention California Customers:

WARNING: Cancer and Reproductive Harm - www.P65Warnings.ca.gov.

Lifetime Warranty

This item is backed by a Limited Lifetime Warranty. In the event this item should fail due to manufacturing defects during intended use, we will exchange the part free of charge (excludes shipping charges) for the original purchaser.

step : Removing the Engine Cover (0:39)

• Loosen the four Phillips clips from the engine cover
• Pull the cover up and out

step : Removing the Ignition Coils 1 & 2 (1:00)

• Press on the tab on the coils with a flat blade screwdriver
• Disconnect the ignition wiring harness
• Pry the coil up and out

step : Installing the New Ignition Coils 1 & 2 (1:25)

• Press the ignition coil into place
• Connect the ignition wiring harness

step : Removing Ignition Coil 3 & 4 (1:37)

• Remove the 10mm bolt from the air box on coil 3
• Remove the air box
• Remove the three 5mm Allen bolts on coil 4
• Remove the bracket
• Press on the tab on the coils with a flat blade screwdriver
• Disconnect the ignition wiring harness
• Pry the coil up and out

step : Installing the New Ignition Coils 3 & 4 (2:30)

• Press the ignition coil into place
• Connect the ignition wiring harness
• Replace the bracket
• Insert and tighten the three 5mm Allen bolts
• Replace the air box
• Insert and tighten the 10mm bolt on the air box

step : Installing the Engine Cover (3:20)

• Push the engine cover down into place
• Tighten the four Phillips clips