Replaces

Volkswagen Beetle Golf Jetta Steering & Suspension Kit - 1ASFK02275

Specifications:

  • Comes as a Set of 6
    • (2) Strut & Spring Assemblies - Fits both LH (Driver Side) & RH (Passenger Side) FRONT
    • (2) Shocks - Fits both LH (Driver Side) & RH (Passenger Side) REAR
    • (2) Inner & Outer Tie Rod Assemblies - Fits both LH (Driver Side) & RH (Passenger Side) FRONT
  • Direct replacements
  • Built to strict quality control standards

 

Our steering and suspension components are sealed for long life and do not require the extra maintenance typically required by greasable versions.

Please Note: Whenever replacing steering components, it is highly recommended to have a professional alignment performed on the vehicle afterwards.  Failure to do so may result in issues with steering and premature tire wear.

Direct Fit

All parts are direct fit, application-specific parts with no modifications required

Rigorously Tested

Rigorously tested and made from higher quality materials than the competition. Our parts are built to have a longer life in any environment or road conditions.

State of the Art Manufacturing

Our parts are manufactured by some of the same factories that the OEMs use.

Prepackaged for Your Convenience

Our kits have been carefully put together to include all of the parts you need to get the job done, saving you both time and money. These kits also help take the guesswork out of finding the correct part for your vehicle’s steering or suspension system, allowing you to get started on your repair project faster.

Lifetime Warranty

This item is backed by a Limited Lifetime Warranty. In the event this item should fail due to manufacturing defects during intended use, we will exchange the part free of charge (excludes shipping charges) for the original purchaser. Please keep your invoice for proof of this warranty.

  1. step : Removing the Wheel (0:55)
    • Remove the lug nut caps with a 7mm Allen bit
    • Insert the lug nut key into the locking lug nut
    • Loosen the lug nuts with the vehicle on the ground
    • Raise the vehicle with a floor jack
    • Secure the vehicle on jack stands
    • Remove the lug nuts
    • Pull off the wheel
  2. step : Removing the Outer Tie Rod (1:47)
    • Measure the distance from the inner tie rod boot to the end of the outer tie rod
    • Record that measurement
    • Loosen the 22mm nut that attaches the inner tie rod to the outer tie rod
    • Use a 6mm Allen wrench and a 19mm wrench to remove the nut at the bottom of the tie rod end
    • Loosen the tie rod by striking the steering knuckle with a hammer
    • Pull the tie rod up and out of the steering knuckle
    • Twist off the outer tie rod
  3. step : Installing the New Outer Tie Rod (2:48)
    • Twist the new outer tie rod onto the inner tie rod
    • Push the outer tie rod into the steering knuckle
    • Fasten the nut onto the outer tie rod with a 19mm wrench and a 6mm Allen wrench
    • Tighten the 19mm nut to 50 foot-pounds of torque
    • Measure the distance from the inner tie rod boot to the end of the outer tie rod
    • Check that this is the same distance as recorded in Step 2
    • Tighten the 22mm nut that attaches the inner tie rod to the outer tie rod
  4. step : Reattaching the Wheel (3:43)
    • Slide the wheel into place
    • Start the lug nuts by hand
    • Tighten the lug nuts preliminarily
    • Lower the vehicle to the ground
    • Tighten the lug nuts to 100 foot-pounds in a crossing or star pattern
    • Attach the lug nut covers

Tools needed for replacement:

    Allen Wrenches

  • 6mm Allen Wrench
  • 7mm Allen Wrench

  • General Tools

  • Measuring Tape
  • Hammer
  • Floor Jack
  • Jack Stands

  • Ratchets & Related

  • Ratchet
  • Torque Wrench

  • Sockets - Metric

  • 19mm Socket
  • 17mm Socket

4.0 / 5.0
1 Review
5 Stars
4 Stars
3 Stars
2 Stars
1 Stars
0
1
0
0
0
The right price and quick delivery.
The price is great, I hope that they last a reasonably long life. Installation videos are a great help as well! I would like to see your site make suggestions on related parts I might need as well. Thank You !
April 5, 2017
Purchased
1 year ago
Start typing your question and we'll check if it was already asked and answered. Learn More
Browse 1 question Browse 1 question and 1 answer
What are the quality of shocks compared to and what is the company producing this kit. I see it is lifetime warranty?
Sandor S on Feb 18, 2017
BEST ANSWER: We have a few different aftermarket companies build these parts specifically for us, as our 1A Auto house brand. They are manufactured to the same OEM specifications as the original part that came with your vehicle. If you have any further questions, please don't hesitate to ask.

Vehicle Fit

  • 1998 VW Beetle (Built After 6/98 Production Date) 6 Piece Set Steering & Suspension Kit
  • 1999-2010 VW Beetle 6 Piece Set Steering & Suspension Kit
  • 1999 VW Golf (Built After 10/98 Production Date) 6 Piece Set Steering & Suspension Kit
  • 2000-2006 VW Golf 6 Piece Set Steering & Suspension Kit
  • 1999 VW Jetta (Built After 10/98 Production Date) 6 Piece Set Steering & Suspension Kit
  • 2000-2004 VW Jetta 6 Piece Set Steering & Suspension Kit
  • 2005 VW Jetta (Built Before 12/30/04 Production Date) 6 Piece Set Steering & Suspension Kit

This part replaces:

  • Monroe 181525
  • Monroe 171525
  • Monroe 5984
  • KYB 343280
  • KYB SR4052
  • Moog ES3709A
  • Moog ES3710A
Part #: 1ASFK02275


How-to Video:

(04:33 min)