Replaces
This part doesn’t fit a . Select from parts that fit.
1A Auto Lifetime Warranty
Frequently bought together
Item Condition:
New
Attention California Customers:
WARNING: This product can expose you to chemicals including Lead and Lead Compounds, which are known to the State of California to cause cancer, and birth defects or other reproductive harm. For more information, go to www.P65Warnings.ca.gov.
Lifetime Warranty
This item is backed by our limited lifetime warranty. In the event this item should fail due to manufacturing defects during intended use, we will replace the part free of charge. This warranty covers the cost of the part only.
Returns: Parts with electrical components cannot be returned once installed.
FREE Shipping is standard on Orders shipped to the lower 48 States (Contiguous United States). Standard shipping charges apply to Hawaii, Alaska and US Territories. Shipping is not available to Canada.
Expedited is available on checkout to the United States, excluding Alaska, Hawaii and US Territories as well as P.O. Boxes and APO/FPO/DPO addresses. Final shipping costs are available at checkout.
Created on:
Tools used
I'm gonna take these two push pins out. Just use a trim tool. Slide those out. Take this push pin out right here. If you have to, you can remove the wheel. We don't have to. There's another push pin right here on the side. Pull that one off. And take this bolt out right here. Use a 10-millimeter socket. And pull the cover, slide it right down. And just use a pick. Get underneath this hose. Loosen it up, twist it back and forth, and slide it off. Just like that. Set that out of the way. Disconnect the connector. Just push down on the lock tab, slide it off. There's a little lock right here. You have to push down on the lock and you should be able to twist the whole thing and then just slide it out. That's where the lock is. It latches if you push down on that right there. Take a rag, clean out that area a little bit. Take the new valve, line it in position, and lock it in place. Take the connector, lock it in place. And then take the hose and slide it on back in position. Take this cover, slide it back in position. And I'm gonna take the bolt, get that started. Before I tighten this up, I'm gonna put the pushpins in. Start with this one on the side and lock that one down, and put the rear ones in. Lock them in place. And get this front one lined up. All right, lock that one in. We're good. Tighten up the bolt.
