This replacement Toyota Tacoma parking light is just what you need to get your Toyota in good looking form again!

Specifications

  • RH (passenger's side)
  • Injection molded plastic
  • DOT (Department of Transportation) & SAE (Society of Automotive Engineers) approved
  • Direct replacement
  • Mounts in the fender
  • Does not include bulbs or wiring

This Toyota Tacoma parking lamp is a great replacement and has good cost savings over a parking light from the dealer.

 

 

Direct Fit Replacement

Direct fit replacement for OEM assembly

Trouble-free Installation

Uses same wiring as original assembly.  No cutting or splicing required.

DOT and SAE Compliant

Meets federal regulations for on-road use

Item Condition: New

WARNING:  This product can expose you to chemicals including Lead and Lead Compounds, which are known to the State of California to cause cancer, and birth defects or other reproductive harm.  For more information, go to www.P65Warnings.ca.gov.

Lifetime Warranty

This item is backed by a Limited Lifetime Warranty. In the event this item should fail due to manufacturing defects during intended use, we will exchange the part free of charge (excludes shipping charges) for the original purchaser.

Bulb Note:

Unless otherwise noted, our lights do not include bulbs, though occasionally lighting manufacturers do include bulbs in the lights. If you happen to receive a lighting product (Headlight, Tail light, parking light, fog light etc.) that comes with the bulbs, the bulbs are not covered under our warranty. Our warranty applies only to the light assembly.

  1. step : Handling the Bulbs (0:32)
    • Note: DO NOT TOUCH the bulbs- the oil from your fingers will burn into the light and foul your bulb.
    • Clean with rubbing alcohol and a soft cloth if the bulbs do get touched.
  2. step : To replace just the headlight bulb (0:33)
    • Pop the hood and secure it.
    • Reach behind the headlight assembly in the engine bay and move the rubber boot and wire retainer to remove the bulbs.
    • Unclip them from the harness and replace.
  3. step : Remove the parking light assembly and front grille (2:10)
    • Remove the Phillips screw on top of the parking light assembly.
    • Unplug the bulb and harness.
    • Pull of the front grill using a long flathead screwdriver to unclip it.
  4. step : Remove the head light assembly (3:55)
    • Remove the two 10 mm nuts and one bolt with your socket and ratchet.
    • Pull out the headlight assembly.
    • Unplug the bulbs and harness.
  5. step : Install the new headlight assembly. (4:55)
    • Plug in the bulbs and harness.
    • Bolt the head light assembly using your 10 mm socket and ratchet.
    • Clip the grill back on.
    • Plug the parking light bulb and harness back in and bolt it back in using your Phillips screwdriver.
    • Close the hood and enjoy your new 1A Auto headlights.

Tools needed for replacement:

    Ratchets & Related

  • Ratchet
  • Socket Extensions

  • Screwdrivers & Related

  • Phillips Head Screwdriver
  • Flat Blade Screwdriver

  • Sockets - Metric

  • 10mm Socket

There are no reviews for this item. Write Review
Start typing your question and we'll check if it was already asked and answered. Learn More
No questions have been asked about this item. Be the first!

Vehicle Fit

Year Make Model Description
1997Toyota Tacoma Toyota Tacoma 4 Wheel Drive (Built After 6/97 Production Date) Corner Light Passenger Side
1998-2000Toyota Tacoma Toyota Tacoma PreRunner Rear Wheel Drive Corner Light Passenger Side
1998-2000Toyota Tacoma Toyota Tacoma 4 Wheel Drive Corner Light Passenger Side

This part replaces:

  • Partslink TO2521154
  • Hollander 116-58645R
  • TYC 18-5261-00
  • DEPO 312-1534R-AS
  • OE # 8161004060
Part #: 1ALPK00340


Order must be placed by 4pm ET

Get it in: 2 - 4 Business Days

Want it sooner? Choose Next Day Air at Checkout

How-to Video:

(06:21 min)