Replaces

Toyota Sequoia Tundra Interior Door Handle - 1ADHI00525

This door handle is just what you need to get your vehicle in good looking form again!

Specifications:

  • Fits LH (Driver Side) FRONT or REAR
  • Replaces dealer part number: 69206-0C040, 692060C040
  • Smooth Black Finish
  • Direct replacement
  • Built to strict quality control standards
  • Fits "SR5" Models only
    • Does NOT fit "Limited" or "Platinum" Models

This door handle is a great replacement and has good cost savings over the dealer unit.

Special Note:

  • This new handle is made to the original color shade.  Due to vehicle age and fading from the sun, our new handles may not match your existing handle or bezel exactly.  If you are looking for an exact match, we recommend replacing handles in pairs or sets.

Lifetime Warranty

This item is backed by a Limited Lifetime Warranty. In the event this item should fail due to manufacturing defects during intended use, we will exchange the part free of charge (excludes shipping charges) for the original purchaser. Please keep your invoice for proof of this warranty.

  1. step : Removing the Front Door Panel (0:23)
    • Pry up the plastic window switch
    • Disconnect the wiring harness
    • Pry off the sail panel
    • Pry out the plastic trim behind the door handle
    • Remove the Phillips screw behind the door handle
    • Remove the Phillips screw in the door pull
    • Pry out the trim clip on the door panel
    • Pry out the door panel
    • Lift the door panel up and off
    • Disconnect the door handle and door lock cables
  2. step : Removing the Interior Door Handle (3:32)
    • Remove the two Phillips screws from the door handle
    • Pry the assembly out with a trim tool
  3. step : Installing the Interior Door Handle (4:10)
    • Insert the door handle into place
    • Tighten the two Phillips screws to the door handle
  4. step : Installing the Front Door Panel (4:43)
    • Connect the door handle and lock cables
    • Lift the door panel on
    • Clip in the door panel
    • Press on the trim clip to the door panel
    • Tighten the Phillips screw to the door pull
    • Tighten the Phillips screw to the door handle
    • Press on the sail panel
    • Connect the wiring harness to the window switch
    • Press on the window switch

Tools needed for replacement:

    Screwdrivers & Related

  • Flat Blade Screwdriver
  • Phillips Head Screwdriver

  • Specialty Tools

  • Trim Tool Set

There are no reviews for this item. Write Review
Start typing your question and we'll check if it was already asked and answered. Learn More
No questions have been asked about this item. Be the first!

Vehicle Fit

  • 2008-2015 Toyota Sequoia SR5 Black Interior Door Handle Driver Side
  • 2007-2015 Toyota Tundra SR5 Black Interior Door Handle Driver Side

This part replaces:

  • OE # 692060C040
  • Dorman 81263
Only 1 left in stock
Part #: 1ADHI00525

How-to Video:

(06:32 min)