Specifications:

  • Fits LH (Driver Side) Front
  • Direct replacement 
  • Built to strict quality control specifications

 

Our electrical and electronic parts are subject to strict quality control testing.  Once the item has been installed or plugged in, it is no longer eligible for a refund.  The item may be eligible for replacement, only if it is found to have a manufacturing defect. Before purchasing, please ensure proper diagnosis of the failed original part is performed

 

Lifetime Warranty

This item is backed by a Limited Lifetime Warranty. In the event this item should fail due to manufacturing defects during intended use, we will exchange the part free of charge (excludes shipping charges) for the original purchaser.

  1. step : Removing the Door Panel (0:19)
    • Pry the courtesy light out of the door panel with a trim tool
    • Disconnect the courtesy light electrical connector
    • Pry the trim piece off the mirror base with a trim tool
    • Pry the grab handle panel off the door handle with a trim tool
    • Pry the trim piece out of the door handle with a trim tool
    • Pry the clip out of the front of the door panel with a trim tool
    • Remove the Phillips screw inside the door handle
    • Remove the two Phillips screws from the grab handle
    • Pry out the door panel clips by hand
    • Lift the door panel off the door
    • Unclip the door lock cable from the door handle
    • Pop the door handle out of the door
    • Disconnect the wiring harness from the door panel
    • Unclip the wiring harness from the door panel
    • Disconnect the door latch cable from the door handle
  2. step : Removing the Master Window Switch (3:07)
    • Remove the three Phillips screws from the window switch
    • Pull the window switch out of the back of the door panel
    • Unlock the window switch electrical connector
    • Disconnect the window switch electrical connector
  3. step : Installing the Master Window Switch (4:31)
    • Connect the electrical connector to the window switch
    • Lock the electrical connector
    • Push the window switch into the back of the door panel
    • Insert the three Phillips screws into the back of the window switch
  4. step : Installing the Door Panel (5:36)
    • Clip the white door cable into the top of the door handle
    • Clip the green door cable into the bottom of the door handle
    • Feed the courtesy light electrical connector through the door panel
    • Connect the electrical connector to the door panel
    • Clip the door handle into the door panel
    • Lift the door panel onto the door
    • Line up the door panel, using the locating pins
    • Push in the door panel clips
    • Insert the Phillips screw inside the door handle
    • Clip the trim into the door handle
    • Insert the two Phillips screws into the grab handle
    • Clip the trim onto the grab handle
    • Clip the trim piece onto the mirror base
    • Push the plastic clip into the front of the door panel
    • Connect the courtesy light electrical connector
    • Push the courtesy light into the door panel

Tools needed for replacement:

    Screwdrivers & Related

  • Phillips Head Screwdriver

  • Specialty Tools

  • Trim Tool Set

There are no reviews for this item. Write Review
Start typing your question and we'll check if it was already asked and answered. Learn More
No questions have been asked about this item. Be the first!

Vehicle Fit

  • 2007-2009 Toyota Camry XLE Front Master Power Window Switch Driver Side
  • 2012-2014 Toyota Camry Front Master Power Window Switch Driver Side
  • 2008-2013 Toyota Highlander Front Master Power Window Switch Driver Side
  • 2012-2014 Toyota Prius C Master Power Window Switch Front Driver Side

This part replaces:

  • Hollander 641-50649BL
  • OE # 8482006061, 8482006060, 8482033250, 8482033251
  • Standard Motor Products DWS-1468
Only 1 left in stock
Part #: 1AWES00282

How-to Video:

(09:31 min)