Toyota Lexus Suspension Kit 4 Piece Set TRQ PSA56199 - 1ASFK01919

Your sway bar helps your vehicle's suspension performance. The main purpose is to reduce body roll when going through a turn at speed. Although the sway bar itself is not a wearable item, the end links and frame bushings are. Over time the ball & socket joints can wear causing loose connections, or even come apart and fall off.

Specifications:

• Comes as a SET of 4
  • Fits both the LH (Driver Side) & RH (Passenger Side) FRONT
• Direct replacements
• Built to strict quality control standards

If you can hear your sway bar rattling on a bumpy road it may be time to replace the end links and bushings. These parts make great replacements and offer good cost savings over the dealer parts.

Our steering and suspension components come pre-greased, sealed for long life, and do not require the extra maintenance typically required by greasable versions.

Application-specific, with no modifications required.

Made from higher quality materials than the competition. Built to have a longer life in any environment or road conditions.

By the same factories that the OEMs use.

Carefully assembled to include all of the parts you need, saving time and money.

Item Condition: New

Attention California Customers:

WARNING: Cancer and Reproductive Harm - www.P65Warnings.ca.gov.

Lifetime Warranty

This item is backed by our limited lifetime warranty. In the event this item should fail due to manufacturing defects during intended use, we will replace the part free of charge.

step : Removing the Wheel (1:17)

• Loosen the lug nuts with the vehicle on the ground
• Raise the vehicle with a floor jack
• Secure the vehicle on jack stands
• Pull off the hub cap
• Remove the lug nuts
• Pull off the wheel

step : Removing the Sway Bar Links (2:52)

• Grab the backside of the joint with locking pliers
• Remove the 14mm nut from the sway bar link
• Repeat the process for the lower end

step : Installing the New Sway Bar Links (5:34)

• Insert the lower end of the sway bar link into place
• Start the 14mm nuts
• Torque the sway bar link nuts to 29 foot-pounds

step : Reattaching the Wheel (6:30)

• Slide the wheel into place
• Start the lug nuts by hand
• Tighten the lug nuts preliminarily
• Lower the vehicle to the ground
• Tighten the lug nuts 76 foot-pounds in a crossing or star pattern
• Reattach the center cap