Description
Warranty & Shipping
How-To & Tools
Product Reviews
Q&A
Vehicle Fit

Specifications:

  • Passenger Side
  • Replaces dealer part number: 81170-48280
  • Includes lens & housing
  • Bulbs not included
Direct Fit Replacement

Direct fit replacement for OEM assembly

Trouble-free Installation

Uses same wiring as original assembly.  No cutting or splicing required.

DOT and SAE Compliant

Meets federal regulations for on-road use

Item Condition: New

Attention California Customers:

WARNING:  This product can expose you to chemicals including Chromium (Hexavalent Compounds), which is known to the State of California to cause cancer, and birth defects or other reproductive harm.  For more information, go to www.P65Warnings.ca.gov.

Lifetime Warranty

This item is backed by a Limited Lifetime Warranty. In the event this item should fail due to manufacturing defects during intended use, we will exchange the part free of charge (excludes shipping charges) for the original purchaser.

Bulb Note:

These lights do not include bulbs.  If you happen to receive a product with bulbs, the bulbs are for testing and not covered under our warranty.  Our warranty applies to the light assembly only.

  1. step : Removing the Grille (0:20)
    • Pry up and remove the push clips from the grille
    • Unclip the grille on either side
    • Slide the grille out
  2. step : Removing the Headlight (1:38)
    • Remove the two 10mm headlights from the top of the headlight
    • Lift the headlight slightly
    • Slide the headlight forward
    • Pry the headlight brackets off the grommets with a trim tool
    • Turn your wheels to access the wheel well
    • Remove the two plastic clips from the wheel well splash shield with a flat blade screwdriver
    • Pull back the splash shield
    • Remove the 10mm bolt behind the splash shield
    • Unclip the bumper beneath the headlight
    • Remove the 10mm bolts from the lower headlight bracket
    • Remove the 10mm nut from the bracket stud
    • Lift the bracket off the stud and pull it aside
    • Pull the headlight off of the frame
    • Unplug the headlight electrical connectors
  3. step : Cleaning Stuck Electrical Connectors (5:39)
    • Apply water displacement oil to loosen any stuck connectors
    • If the connectors remain stuck, twist the bulbs counterclockwise out of the headlight
    • Pull the bulbs off the stuck connectors
    • Clean the connectors with water displacement oil, paper towels, and electrical contact cleaner
    • Clean dirt out of the connectors with compressed air
  4. step : Installing the Headlight (9:41)
    • Remove the bulb caps from the new headlight
    • If you removed bulbs from the connectors, twist them counterclockwise into the headlight
    • Plug the electrical connectors into the bulbs
    • Slide the headlight onto the frame using the locating pins
    • Place the lower headlight bracket onto the stud
    • Install the 10mm bolts into the bracket
    • Fasten the 10mm nut onto the bracket stud
    • Install the two 10mm bolts at the top of the headlight
    • Clip the bumper into place
    • Install the 10mm bolt behind the wheel well splash shield
    • Push the splash shield behind the bumper
    • Push the plastic clips into the splash shield
  5. step : Installing the Grille (14:43)
    • Clip the grille underneath the lip and slide the grille in place
    • Replace the push clips
  6. step : Aiming the Headlights (15:55)
    • Make a dot at the center of your low beam light with a dry erase marker
    • Measure from the ground to the center of the dot
    • Line up your vehicle with a dark flat surface
    • Mark the center of each headlight on the aiming surface
    • Draw a straight line between the two marks
    • back the vehicle up 25 feet from the aiming surface
    • Turn the headlights on
    • Adjust the passenger side aiming screw until the focus of the passenger side light beam is two inches below the line on the aiming surface
    • Adjust the driver side aiming screw until the focus of the driver side light beam is four inches below the line on the aiming surface

Tools needed for replacement:

    Materials, Fluids, and Supplies

  • Gloves

  • Ratchets & Related

  • Socket Extensions
  • Ratchet

  • Screwdrivers & Related

  • Flat Blade Screwdriver
  • Phillips Head Screwdriver

  • Sockets - Metric

  • 10mm Socket

  • Specialty Tools

  • Trim Tool Set

There are no reviews for this item.
Will this fit my car? Add a vehicle to make sure
Customer Q&A
Ask a question to 1A Auto customers who purchased the product
No questions have been asked about this item.
Year Make Model Description
2004-2005Toyota Highlander Toyota Highlander Headlight Passenger Side
2006Toyota Highlander Toyota Highlander (excluding Hybrid Models) Headlight Passenger Side
Part #: 1ALHL01240


Order must be placed by 4pm ET

Get it in: 2 - 4 Business Days

Want it sooner? Choose Next Day Air at Checkout

How-to Video:

(17:24 min)