Toyota Camry Solara Exhaust Pipe with Catalytic Converter - 1ACCD00267


  • Replaces Front Exhaust Pipe with REAR converter
  • Replaces dealer part numbers: 17410-0H180, 174100H180, 17410-0H150, 174100H150, 410-0H160, 174100H160
  • Details:
    • Inlet:
      • 2 Bolt diamond flange
    • Outlet:
      • 2 Bolt diamond flange
  • High quality 409 grade stainless steel
  • Includes all Pipes and flanges for direct installation (additional clamps may be required)
  • Certified for the following agencies:
    • US Environmental Protection Agency (EPA)
    • Ministry of Environment, Ontario & British Columbia - Canada
  • Built to strict quality control standards

Note:  This converter is not monitored;  the downstream oxygen sensor is located before this converter.


5 Year Warranty

This item is backed by a 5 Year Warranty. In the event this item should fail during intended use, we will exchange the part free of charge (excludes shipping charges) for the original purchaser. 

Emissions Note:

Due to state emissions regulations, we cannot ship this item to the state of California as it is not C.A.R.B ( California Air Research Board) approved for use in this state.

Due to New York state emissions regulations, this item cannot be installed on a California emissions equipped vehicle in the state of New York.

All emissions information for a vehicle can be found on a tag under the hood. If the tag is missing, you can contact a dealership with your VIN to determine which emissions system your vehicle is equipped with.

  1. step : Removing the Front Pipe with the Flex Pipe and Cat Converter (1:12)
    • Jack up and support the vehicle on jack stands
    • Remove the three 14mm nuts on the front pipe flange on the bottom of the exhaust manifold
    • Unbolt the two 12mm bolts securing the exhaust before the flex pipe
    • Remove the two 12mm bolts securing the exhaust hanger to the subframe
    • Lower and remove the exhaust
  2. step : Installing the Front Pipe with the Flex Pipe and Cat Converter (4:20)
    • Insert the hanger over the arm
    • Line the front studs of the exhaust manifold into place
    • Reinstall the two 12mm bolts on the hanger
    • Tighten the 12mm bolts with a socket and ratchet
    • Clean the surface before installing the new gasket
    • Insert the 14mm hardware into place and tighten the convertor to the pipe
    • Tighten the hardware as tight as possible evenly to seal the gasket
    • Attach a gasket onto the end pipe
    • Tighten the two 12mm bolts to the brace around the exhaust pipe
    • Tighten the 14mm nuts to the front pipe flange

Tools needed for replacement:

    General Tools

  • Jack Stands
  • Floor Jack

  • Materials, Fluids, and Supplies

  • Rust Penetrant

  • Ratchets & Related

  • Ratchet
  • Socket Extensions

  • Sockets - Metric

  • 14mm Socket
  • 12mm Socket

  • Wrenches - Metric

  • 12mm Wrench
  • 14mm Wrench

4.8 / 5.0
4 Reviews
5 Stars
4 Stars
3 Stars
2 Stars
1 Star
Perfect Fit
Was able to put this on and it fit perfectly on my 2002 Toyota Camry. Was able to pass emission test as well!
February 22, 2018
5 months ago
Fast transit
I was very happy with the fitment of this exhaust pipe and also surprised that it has a 5 year 50,000 mile warranty.
November 30, 2017
8 months ago
Perfect fit
This was a perfect fit, from ordering the part,shipping and instillation.
Your staff was most helpful and the price was excellent.
The thanks for a great experience.
October 23, 2017
9 months ago
No O2 Sensor plugs
Fit fine. No problems there. But it had 3 holes for O2 sensors and I only needed one of them. Had to purchase plus at $15 each to close them up. But that's not the best part. When I told the NAPA salesman what I had to do, he said they had oil drain plugs the same size for $3 each. I took the other plugs back to Pep Boys for a refund.
January 24, 2017
1 year ago
Start typing your question and we'll check if it was already asked and answered. Learn More
Browse 3 questions Browse 3 questions and 7 answers
hi, does this include required gaskets ?
saulius on Nov 22, 2015
BEST ANSWER: Hello, Sorry but the gaskets are not included with this item. They are available at your local auto parts store for a small dollar amount.
What brand is this product ?
Sean B on Oct 3, 2017
BEST ANSWER: We have a few different aftermarket companies build these parts specifically for us, as our 1A Auto house brand. They are manufactured to the same OEM specifications as the original part that came with your vehicle. If you have any further questions, please don't hesitate to ask.
This part will fit for 1999 camry ce ?
Tades on Dec 2, 2016

Vehicle Fit

  • 2002-2010 Toyota Camry Exhaust Pipe with Catalytic Converter L4 2.4L
  • 2004-2006 Toyota Solara Exhaust Pipe with Catalytic Converter L4 2.4L

This part replaces:

  • OE # 174100H180
Part #: 1ACCD00267

How-to Video:

(06:53 min)