This replacement mirror set is just what you need to get your vehicle in good working condition again!

Mirror specifications:

  • Driver and Passenger Side
  • Power mirror
  • Injection molded black plastic housing
  • Can be painted by the buyer to any color desired or installed as is
  • Direct replacement
  • Built to strict quality control standards

This mirror set makes a great replacement and has good cost savings over a dealer part.

Special Note:

  • This mirror will only work properly on vehicles with these exact options. If your vehicle does not have the options listed in specifications, the mirror may not function properly.

Lifetime Warranty

This item is backed by a Limited Lifetime Warranty. In the event this item should fail due to manufacturing defects during intended use, we will exchange the part free of charge (excludes shipping charges) for the original purchaser. Please keep your invoice for proof of this warranty.

  1. step : Removing the Door Panel (0:44)
    • Pry up the window switch panel by hand
    • Disconnect the door lock wiring harness
    • Disconnect the window switch wiring harnesses
    • Pry off the door pull trim with a flat blade screwdriver
    • Remove the two Phillips head screws inside the door pull
    • Remove the Phillips head screw inside the door handle
    • Push the center of the pin on the each side of the door panel with a flat blade screwdriver
    • Remove the pin
    • Pull the door handle forward and out
    • Pull the door lock rod clip out towards you
    • Lift the door lock rod off the door handle
    • Pry out the door panel with a door panel clip tool or putty knife
    • Lift the door panel up and off
  2. step : Removing the Rear View Mirror (3:34)
    • Pry off the mirror base trim piece with a flat blade screwdriver
    • Carefully pull back part of the water shield
    • Disconnect the speaker wiring lead
    • Unclip the speaker wiring lead from the door with a flat blade screwdriver
    • Remove the Phillips screw from the speaker
    • Remove the three 10mm bolts holding the mirror
    • Pull the mirror free from the assembly clip
    • Lift the mirror up and off
  3. step : Installing the New Rear View Mirror (5:30)
    • Clip the mirror into place
    • Insert the three 10mm bolts that hold the mirror
    • Clip the speaker wiring into the door and plug the wiring lead in
    • Insert the Phillips screw into the speaker
    • Re-clip the mirror base trim piece
    • Replace the water shield
  4. step : Reinstalling the Door Panel (7:09)
    • Put the water shield into place
    • Lift the door panel into place
    • Push in the door panel clips
    • Connect the latch cables to the door handle
    • Connect the door lock wiring harness
    • Connect the window switch wiring harnesses
    • Clip in the switch panel
    • Lift the door panel into place
    • Push in the door panel clips
    • Replace the door handle bezel
    • Insert the Phillips head screw inside the door handle
    • Clip in the door pull handle panel
    • Insert the two Phillips head screws inside the door pull

Tools needed for replacement:

    General Tools

  • Putty Knife

  • Ratchets & Related

  • Ratchet

  • Screwdrivers & Related

  • Phillips Head Screwdriver
  • Flat Blade Screwdriver

  • Sockets - Metric

  • 10mm Socket

  • Wrenches - Metric

  • 10mm Wrench

There are no reviews for this item. Write Review
Start typing your question and we'll check if it was already asked and answered. Learn More
No questions have been asked about this item. Be the first!

Vehicle Fit

  • 1999 Toyota 4Runner (Built After 6/99 Production Date) Power Mirror Pair
  • 2000-2002 Toyota 4Runner Power Mirror Pair
Only 1 left in stock
Part #: 1AMRP00316

How-to Video:

(08:26 min)