• Comes as a Set of 4
    • Fits LH (Driver Side) & RH (Passenger Side)
  • Direct replacements
  • Built to strict quality control standards

Our steering and suspension components are sealed for long life and do not require the extra maintenance typically required by greasable versions.

Please Note: Whenever replacing steering components, it is highly recommended to have a professional alignment performed on the vehicle afterwards.  Failure to do so may result in issues with steering and premature tire wear.

Item Condition: New

WARNING: Cancer and Reproductive Harm - www.P65Warnings.ca.gov.

Lifetime Warranty

This item is backed by a Limited Lifetime Warranty. In the event this item should fail due to manufacturing defects during intended use, we will exchange the part free of charge (excludes shipping charges) for the original purchaser.

    It is recommended to seek a professional alignment after completing this repair.

  1. step : Removing the Wheel (0:50)
    • Loosen the lug nut covers with a 19mm socket
    • Pry off the center cap with a flat blade screwdriver
    • Loosen the lug nuts with the vehicle on the ground
    • Raise the vehicle with a floor jack
    • Secure the vehicle on jack stands
    • Remove the lug nuts
    • Pull off the wheel
  2. step : Removing the Outer Tie Rod (1:08)
    • Measure the distance from the boot of the inner tie rod to the edge of the outer tie rod
    • Make note of this measurement
    • Loosen the nut that holds the outer tie rod to the inner tie rod with an adjustable wrench
    • Remove the 18mm nut from the outer tie rod end
    • Loosen the nut that holds the outer tie rod to the inner tie rod with an adjustable wrench
    • Strike the steering knuckle with a hammer to loosen the outer tie rod
    • Pull the outer tie rod out of the steering knuckle
    • Twist off the outer tie rod by hand
  3. step : Installing the New Outer Tie Rod (1:55)
    • Twist the new outer tie rod onto the inner tie rod
    • Push the outer tie rod into the steering knuckle
    • Place vise grip pliers to hold the other part of the ball joint
    • Fasten the 18mm nut onto the outer tie rod with a socket
    • Place the pliers on the bottom of the bolt
    • Tighten the nut with an 18mm wrench
    • Tighten the nut that holds the outer tie rod to the inner tie rod with an adjustable wrench
    • Measure the distance from the boot of the inner tie rod to the edge of the outer tie rod
    • This should be the same as the measurement noted in Step 2
  4. step : Reattaching the Wheel (3:29)
    • Slide the wheel into place
    • Start the lug nuts by hand
    • Tighten the lug nuts preliminarily
    • Lower the vehicle to the ground
    • Tighten the lug nuts to 100 foot-pounds in a crossing or star pattern
    • Reattach the center cap
    • Tighten the lug nut covers with a 19mm socket

Tools needed for replacement:

    General Tools

  • Measuring Tape
  • Jack Stands
  • Hammer
  • Floor Jack

  • Pliers, Cutters & misc Wrenches

  • Vise Grip Pliers
  • Adjustable Wrench

  • Ratchets & Related

  • Torque Wrench
  • Ratchet

  • Sockets - Metric

  • 18mm Socket
  • 19mm Socket

  • Wrenches - Metric

  • 18mm Wrench

  • Wrenches - SAE

  • 13/16 Inch Wrench

4.6 / 5.0
9 Reviews
5 Stars
4 Stars
3 Stars
2 Stars
1 Star
Not the best I've used
I buy many products from 1A Auto and 99% of them are excellent. These tie rod ends didn't last five thousand miles. The boot is torn on both outer tie rod ends. Do not seem to be the high quality that I expect and usually get from 1A Auto. Will try to find a different brand elsewhere I guess
September 30, 2018
11 months ago
Response from 1A Auto
Thank you for your feedback. We are sorry to hear that you were unhappy with the part you received. We strive for 100% customer satisfaction and would like the opportunity to make this right for you. Please feel free to contact us at 888-844-3393 so we can identify a suitable resolution for you. We hope to hear from you soon.
October 1, 2018
Christa R
Tie rods
Very good quality parts. matched up perfectly to old parts and install was very easy.
August 1, 2018
4 months ago
On point
What can I say this site is awesome,the parts are original & beautifully priced.Plus they step by step videos to help you on your car & save you money.??
July 12, 2018
3 months ago
Tie rod
Ordered these parts for mother’s vehicle. Shipped and received quickly and no issues with installation.
May 25, 2018
5 months ago
Tire end rod
purchased a set of tire end rods, very satisfied and for that price you can’t beat it. I will be purchasing a set for my wife real soon
May 22, 2018
5 months ago
Quality Parts Cheap Prices
I shop at 1A Auto the same reason I shop at Harbor Freight good products with cheap prices... I have never gone wrong purchasing anything from here parts came quick and fit nicely
April 28, 2018
6 months ago
Quality parts
Parts are just as good as napa auto parts but cheaper
April 25, 2018
7 months ago
Exactly What I Ordered
I have yet to install the parts I ordered on my vehicle. Although I give an A+ for the ease of ordering and the timeliness in which my parts arrived. I can't wait to get them on my car and let you know how great they are. :)
March 31, 2018
7 months ago
The parts fit great. Easy to install. Will use them in the future. Great website.
December 4, 2017
10 months ago
Start typing your question and we'll check if it was already asked and answered. Learn More
Browse 1 question Browse 1 question and 4 answers
Who makes these tie rods? And is there a need for a special tool for the inside tie rods?
Cody S on Oct 14, 2016
BEST ANSWER: I do not recall the mfg., but the quality was excellent. A very good deal.. Yes, a special tool was required. I believe I borrowed it from Advance Auto. No charge, just a deposit, that was returned to my credit card. My son hit a chuck hole. Damaged wheel bearing, and inter tie rod housing cracked. Once completed, worked great. Good Luck

Vehicle Fit

Year Make Model Description
2004-2012Chevy Malibu Chevy Malibu Front Inner & Outer Tie Rod 4 Piece Set
2004-2007Chevy Malibu Maxx Chevy Malibu Maxx Front Inner & Outer Tie Rod 4 Piece Set
2005-2010Pontiac G6 Pontiac G6 Front Inner & Outer Tie Rod 4 Piece Set
2007-2009Saturn Aura Saturn Aura Front Inner & Outer Tie Rod 4 Piece Set

This part replaces:

  • Moog ES800086
  • Moog EV80988
  • OE # 15944097
  • OE # 15944072
  • OE # 22687091
  • OE # 15944090
  • OE # 22687089
Part #: 1ASFK01895

Order must be placed by 4pm ET

Get it in: 2 - 4 Business Days

Want it sooner? Choose Next Day Air at Checkout

How-to Video:

(04:22 min)