Part Details

  • Quantity: 4 Piece Set

Specifications:

  • Comes as a Set of 4
    • Fits LH (Driver) & RH (Passenger Side)
  • Direct replacements
  • Built to strict quality control standards

 

Our steering and suspension components are sealed for long life and do not require the extra maintenance typically required by greasable versions.

Please Note: Whenever replacing steering components, it is highly recommended to have a professional alignment performed on the vehicle afterwards.  Failure to do so may result in issues with steering and premature tire wear.

Item Condition: New

WARNING: Cancer and Reproductive Harm - www.P65Warnings.ca.gov.

Lifetime Warranty

This item is backed by a Limited Lifetime Warranty. In the event this item should fail due to manufacturing defects during intended use, we will exchange the part free of charge (excludes shipping charges) for the original purchaser.

  1. step : Removing the Wheel (0:45)
    • Remove the lug nut covers with a 19mm socket
    • Pull off the hub cap
    • Loosen the lug nuts with the vehicle on the ground
    • Raise the vehicle with a floor jack
    • Secure the vehicle on jack stands
    • Remove the lug nuts
    • Pull off the wheel
  2. step : Removing the Outer Tie Rod (1:18)
    • Twist the cotter pin out of the tie rod nut with needle nose pliers
    • Remove the 18mm nut from the tie rod
    • Measure from the boot of the inner tie rod to the center of the outer tie rod
    • Note this measurement
    • Loosen the 7/8 inch nut that holds the inner to the outer tie rod
    • Thread the 18mm nut onto the tie rod slightly
    • Strike the tie rod with a hammer to loosen it from the spindle
    • Twist off the outer tie rod
  3. step : Installing the New Outer Tie Rod (2:32)
    • Attach the grease fitting to the new outer tie rod
    • Tighten the grease fitting with a 7mm socket and ratchet
    • Twist the outer tie rod onto the inner tie rod
    • Push the tie rod into the spindle
    • Thread the 18mm nut onto the tie rod
    • Measure the distance from the boot to the center of the tie rod
    • This measurement should match the one taken in Step 2
    • Adjust the tie rod as necessary
    • Tighten the 18mm nut
    • Put the cotter pin through the 18mm nut and fold it over with needle nose pliers
    • Hold the nut that connects the inner to the outer tie rod with a 7/8 inch wrench
    • Turn the inner tie rod with a 13mm wrench
    • Add grease to the grease fitting with a grease gun
  4. step : Reattaching the Wheel (3:58)
    • Slide the wheel into place
    • Start the lug nuts by hand
    • Tighten the lug nuts preliminarily
    • Lower the vehicle to the ground
    • Tighten the lug nuts to 100 foot-pounds in a crossing or star pattern
    • Put on the hub cap, lining up the hole with the valve stem
    • Tighten the lug nut covers with a 19mm socket

Tools needed for replacement:

    General Tools

  • Floor Jack
  • Jack Stands
  • Measuring Tape

  • Materials, Fluids, and Supplies

  • Bearing Grease

  • Pliers, Cutters & misc Wrenches

  • Needle nose pliers

  • Ratchets & Related

  • Ratchet

  • Sockets - Metric

  • 18mm Socket
  • 19mm Socket
  • 7mm Socket

  • Wrenches - Metric

  • 13mm Wrench
  • 22mm Wrench

  • Wrenches - SAE

  • 7/8 Inch Wrench

5.0 / 5.0
1 Review
5 Stars
4 Stars
3 Stars
2 Stars
1 Star
1
0
0
0
0
When I need Quality Parts for my Buick Century. I pick 1AAuto good service and professional people. Thank You 1AAuto
April 20, 2018
Purchased
5 months ago
Start typing your question and we'll check if it was already asked and answered. Learn More
Browse 1 question Browse 1 question and 1 answer
How many tie rods do I need to buy if I need inner and outer tie rods on my 2000 Buick century?
Ki'Ara F on May 14, 2018
BEST ANSWER: just one kit. it comes with one inner and one outer for each side.

Vehicle Fit

Year Make Model Description
1997-2005Buick Century Buick Century Inner & Outer Tie Rod 4 Piece Set
2005-2009Buick LaCrosse Buick LaCrosse Inner & Outer Tie Rod 4 Piece Set
1997-2004Buick Regal Buick Regal Inner & Outer Tie Rod 4 Piece Set
2000-2003Chevy Impala Chevy Impala Inner & Outer Tie Rod 4 Piece Set
2004-2013Chevy Impala Chevy Impala Inner & Outer Tie Rod 4 Piece Set without RPO Code FE4 (Special Ride & Handling Suspension)
2014-2016Chevy Impala Limited Chevy Impala Limited Inner & Outer Tie Rod 4 Piece Set without RPO Code FE4 (Special Ride & Handling Suspension)
2000-2007Chevy Monte Carlo Chevy Monte Carlo Inner & Outer Tie Rod 4 Piece Set
1998-2002Oldsmobile Intrigue Olds Intrigue Inner & Outer Tie Rod 4 Piece Set
2004-2008Pontiac Grand Prix Pontiac Grand Prix Inner & Outer Tie Rod 4 Piece Set

This part replaces:

  • Moog EV195
  • Moog ES3459
  • OE # 26021769
Part #: 1ASFK01833


Order must be placed by 4pm ET

Get it in: 2 - 4 Business Days

Want it sooner? Choose Next Day Air at Checkout

How-to Video:

(04:49 min)