MOOG ES3438 [FRONT OUTER TIE ROD END]

This Moog brand front outer tie rod end is just what you need to ensure the safety and integrity of your vehicle's suspension and steering.

Specifications:

  • Fits either LH (Driver Side) or RH (Passenger Side) OUTER
  • Replaces one of many dealer part numbers including: 48520-0M085, D8520-15U26, 485200M085, D852015U26
  • Connects to inner tie rod
  • Direct replacement
  • Built to strict quality control standards
  • Grease-able

When installed correctly and an alignment performed, this outer tie rod could also reduce uneven tire wear.

Lifetime Warranty

This item is backed by a Limited Lifetime Warranty. In the event this item should fail due to manufacturing defects during intended use, we will exchange the part free of charge (excludes shipping charges) for the original purchaser.

  1. step : remove the wheel (0:50)
    • Loosen your lug nuts
    • Raise and secure your vehicle
    • Remove the lug nuts and the wheel
  2. step : Remove the tie rod (1:13)
    • Measure your tie rod to help make a preliminary alignment later.
    • Remove the cotter pin in the castle nut.
    • Remove the 19 mm castle nut.
    • Use a hammer to break the tie rod free and lift it up and out.
    • Unscrew the outer tie rod and remove it.
  3. step : Install the new outer tie rod (2:09)
    • Install the grease fitting.
    • Put the outer tie rod onto the inner tie rod.
    • Place the tie rod end into the knuckle.
    • Replace the 19 mm castle nut.
    • Measure your tie rod and make sure it is the same distance as the old one.
    • Tighten up the middle nut when it is.
    • Put your cotter pin into the castle nut.
  4. step : Put your wheel back on (3:30)
    • Thread the lug nuts.
    • Lower the vehicle
    • Tighten the lug nuts to 100 ft lbs.

Tools needed for replacement:

    General Tools

  • Floor Jack
  • Hammer
  • Jack Stands

  • Pliers, Cutters & misc Wrenches

  • Needle nose pliers

  • Ratchets & Related

  • Ratchet

  • Sockets - Metric

  • 19mm Socket
  • 21mm Socket
  • 7mm Socket

There are no reviews for this item. Write Review
Start typing your question and we'll check if it was already asked and answered. Learn More
No questions have been asked about this item. Be the first!

Vehicle Fit

  • 1996-2001 Infiniti I30 Outer Tie Rod Driver or Passenger Side MOOG ES3438
  • 2002-2004 Infiniti I35 Outer Tie Rod Driver or Passenger Side MOOG ES3438
  • 1989-1998 Nissan 240SX Outer Tie Rod Driver or Passenger Side MOOG ES3438
  • 2002-2004 Nissan Altima Outer Tie Rod Driver or Passenger Side MOOG ES3438
  • 1995-2008 Nissan Maxima Outer Tie Rod Driver or Passenger Side MOOG ES3438

This part replaces:

  • MOOG ES3438
  • OE # D852015U26
  • OE # 485200M085
Part #: 1ASTE00053

MOOG
Brand #: ES3438

How-to Video:

(04:01 min)