These tie rod ends are just what you need to ensure the safety and integrity of your vehicle's suspension and steering.

Specifications:

  • Comes as a PAIR
    • Fits both LH (Driver Side) & RH (Passenger Side) FRONT OUTER
  • Direct replacements
  • Built to strict quality control standards

Remember whenever you are replacing any front end or steering components you should have your vehicle professionally aligned as soon as possible. This will ensure proper tracking and even tire wear.

Our steering and suspension components are sealed for long life and do not require the extra maintenance typically required by greasable versions.

Please Note: Whenever replacing steering components, it is highly recommended to have a professional alignment performed on the vehicle afterwards.  Failure to do so may result in issues with steering and premature tire wear.

Lifetime Warranty

This item is backed by a Limited Lifetime Warranty. In the event this item should fail due to manufacturing defects during intended use, we will exchange the part free of charge (excludes shipping charges) for the original purchaser. Please keep your invoice for proof of this warranty.

  1. step : Removing the Wheel (0:25)
    • Loosen the five 19mm lug nuts
    • Raise and support the vehicle
    • Remove the lug nuts
    • Slide the wheel off the hub
  2. step : Removing the Tie Rod End (0:55)
    • Remove the cotter pin from the castle nut
    • Remove the castle nut with a 13/16" wrench
    • Strike the wheel knuckle with a hammer to loosen the tie rod end
    • Twist the tie rod end off the inner tie rod, counting how many rotations it takes to remove
  3. step : Installing the Tie Rod End (2:35)
    • Remove the jam nut from the old tie rod end
    • Thread the jam nut onto the new tie rod end
    • Start the tie rod end onto the inner tie rod
    • Turn the tie rod end in, the same number of turns it took to remove
    • Line up the tie rod end into the wheel knuckle
    • Fasten the castle nut onto the tie rod end
    • Line up the castle nut with the hole in the tie rod end
    • Feed the cotter pin through the hole
    • Bend the cotter pin with pliers to secure it
  4. step : Installing the Wheel (3:56)
    • Slide the wheel onto the hub
    • Start the lug nuts
    • Lower the vehicle to the ground
    • Tighten the lug nuts to between 83 and 112 foot-pounds of torque in a star pattern
There are no reviews for this item. Write Review
Start typing your question and we'll check if it was already asked and answered. Learn More
No questions have been asked about this item. Be the first!

Vehicle Fit

  • 1997-2002 Ford Expedition Front Outer Tie Rod Pair
  • 2004 Ford F150 Heritage Truck Front Outer Tie Rod Pair
  • 1997-2003 Ford F150 Truck Front Outer Tie Rod Pair
  • 1997-1999 Ford F250 Light Duty Truck Front Outer Tie Rod Pair
  • 2002 Lincoln Blackwood Front Outer Tie Rod Pair
  • 1998-2002 Lincoln Navigator Front Outer Tie Rod Pair

This part replaces:

  • Moog ES3366T
  • Moog ES3367T
Part #: 1ASFK00452

How-to Video:

(04:52 min)