These outer tie rod ends are just what you need to ensure the safety and integrity of your vehicle's suspension and steering.


  • Comes as a PAIR
    • Fits both LH (Driver Side) & RH (Passenger Side) FRONT
  • Replaces dealer part numbers: 52013468AC, 52106710AC, 52106710AB, 52106710AA, 5098996AA
  • Connects to inner tie rods
  • Direct replacements
  • Built to strict quality control standards

Remember whenever you are replacing any front end or steering components you should have your vehicle professionally aligned as soon as possible. This will ensure proper tracking and even tire wear.

Our steering and suspension components are sealed for long life and do not require the extra maintenance typically required by greasable versions.

Please Note: Whenever replacing steering components, it is highly recommended to have a professional alignment performed on the vehicle afterwards.  Failure to do so may result in issues with steering and premature tire wear.

Lifetime Warranty

This item is backed by a Limited Lifetime Warranty. In the event this item should fail due to manufacturing defects during intended use, we will exchange the part free of charge (excludes shipping charges) for the original purchaser. Please keep your invoice for proof of this warranty.

  1. step : Removing the Wheel (0:47)
    • Loosen the lug nuts
    • Raise and support the vehicle
    • Remove the lug nuts
    • Pull off the wheel
  2. step : Removing the Outer Tie Rod (1:14)
    • Soak the tie rod jam nut and the other tie rod nut in rust penetrant
    • Loosen the jam nut with a 24mm wrench
    • Remove the 21mm nut from the outer tie rod
    • Strike the wheel spindle with a hammer to release the outer tie rod
    • Pull the tie rod down out of the wheel spindle
    • Twist off the tie rod, counting how many turns it takes to remove
    • Hold the inner tie rod with locking pliers
    • Mark the jam nut position with a marker
    • Twist off the jam nut with a 24mm wrench, counting how many turns it takes to remove
  3. step : Installing the Outer Tie Rod (5:25)
    • Mark the new jam nut
    • Twist on the new jam nut the same number of turns it took to remove the old one
    • Twist on the outer tie rod the same number of turns it took to remove the old one
    • Insert the outer tie rod stud into the wheel spindle
    • Fasten the 22mm nut onto the outer tie rod
    • Tighten the 22mm nut to 63 foot-pounds of torque
    • Tighten the new jam nut with a 22mm wrench
    • Grease the tie rod fitting until the boot swells
  4. step : Installing the Wheel (7:04)
    • Lift the wheel into place
    • Start the lug nuts
    • Lower the vehicle to the ground
    • Tighten the lug nuts to 110 foot-pounds

Tools needed for replacement:

    General Tools

  • Jack Stands
  • Hammer
  • Floor Jack

  • Materials, Fluids, and Supplies

  • Gloves
  • Rust Penetrant
  • Marker / Writing Utensil

  • Pliers, Cutters & misc Wrenches

  • Vise Grip Pliers
  • Side Cutters

  • Ratchets & Related

  • Ratchet
  • Torque Wrench
  • Socket Extensions
  • 1/2 Inch Breaker Bar

  • Sockets - Metric

  • Complete Metric Socket Set

4.0 / 5.0
1 Review
5 Stars
4 Stars
3 Stars
2 Stars
1 Stars
Everything went well, my purchase and delivery went smoothly. Will definitely consider utilizing this method again. Thanks!
August 8, 2017
11 months ago
Start typing your question and we'll check if it was already asked and answered. Learn More
Browse 2 questions Browse 2 questions and 7 answers
How do you grease the boot?
greg s on Sep 26, 2017
BEST ANSWER: With a hand held pump grease gun that you can pickup at any auto parts store or from your favorite online vendor/store, such as Amazon, eBay, or Walmart.
Does this part come with nuts and bolts?
Daniel G on Sep 3, 2015
BEST ANSWER: Yes it comes with everything you need.

Vehicle Fit

  • 2005-2010 Chrysler 300 Front Outer Tie Rod Pair Rear Wheel Drive
  • 2008-2010 Dodge Challenger Front Outer Tie Rod Pair
  • 2006-2010 Dodge Charger Front Outer Tie Rod Pair Rear Wheel Drive
  • 2000-2004 Dodge Dakota 2 Wheel Drive Front Outer Tie Rod Pair
  • 2005-2010 Dodge Dakota Outer Tie Rod Front Pair
  • 2000-2003 Dodge Durango 2 Wheel Drive Front Outer Tie Rod Pair
  • 2005-2008 Dodge Magnum Front Outer Tie Rod Pair Rear Wheel Drive
  • 2006-2009 Mitsubishi Raider Front Outer Tie Rod Pair
  • 2011 Ram Dakota Front Outer Tie Rod Pair

This part replaces:

  • OE # 52013468AC
  • OE # 52106710AC x2
  • Moog ES3571
  • OE # 52013468AC, 52106710AC
  • OE # 52013468AC, 52106710AC x2
Part #: 1ASFK00222

How-to Video:

(07:32 min)