This outer tie rod end is just what you need to ensure the safety and integrity of your vehicle's suspension and steering.

Specifications:

  • Fits either LH (Driver Side) or RH (Passenger Side) FRONT
  • Replaces dealer part numbers: 52013468AC, 52106710AC, 52106710AB, 52106710AA, 5098996AA
  • Connects to inner tie rod
  • Direct replacement
  • Built to strict quality control standards

Remember whenever you are replacing any front end or steering components you should have your vehicle professionally aligned as soon as possible. This will ensure proper tracking and even tire wear.

Our steering and suspension components are sealed for long life and do not require the extra maintenance typically required by greasable versions.

Please Note: Whenever replacing steering components, it is highly recommended to have a professional alignment performed on the vehicle afterwards.  Failure to do so may result in issues with steering and premature tire wear.

Lifetime Warranty

This item is backed by a Limited Lifetime Warranty. In the event this item should fail due to manufacturing defects during intended use, we will exchange the part free of charge (excludes shipping charges) for the original purchaser.

  1. step : Removing the Wheel (0:47)
    • Loosen the lug nuts
    • Raise and support the vehicle
    • Remove the lug nuts
    • Pull off the wheel
  2. step : Removing the Outer Tie Rod (1:14)
    • Soak the tie rod jam nut and the other tie rod nut in rust penetrant
    • Loosen the jam nut with a 24mm wrench
    • Remove the 21mm nut from the outer tie rod
    • Strike the wheel spindle with a hammer to release the outer tie rod
    • Pull the tie rod down out of the wheel spindle
    • Twist off the tie rod, counting how many turns it takes to remove
    • Hold the inner tie rod with locking pliers
    • Mark the jam nut position with a marker
    • Twist off the jam nut with a 24mm wrench, counting how many turns it takes to remove
  3. step : Installing the Outer Tie Rod (5:25)
    • Mark the new jam nut
    • Twist on the new jam nut the same number of turns it took to remove the old one
    • Twist on the outer tie rod the same number of turns it took to remove the old one
    • Insert the outer tie rod stud into the wheel spindle
    • Fasten the 22mm nut onto the outer tie rod
    • Tighten the 22mm nut to 63 foot-pounds of torque
    • Tighten the new jam nut with a 22mm wrench
    • Grease the tie rod fitting until the boot swells
  4. step : Installing the Wheel (7:04)
    • Lift the wheel into place
    • Start the lug nuts
    • Lower the vehicle to the ground
    • Tighten the lug nuts to 110 foot-pounds

Tools needed for replacement:

    General Tools

  • Jack Stands
  • Hammer
  • Floor Jack

  • Materials, Fluids, and Supplies

  • Gloves
  • Rust Penetrant
  • Marker / Writing Utensil

  • Pliers, Cutters & misc Wrenches

  • Vise Grip Pliers
  • Side Cutters

  • Ratchets & Related

  • Ratchet
  • Torque Wrench
  • Socket Extensions
  • 1/2 Inch Breaker Bar

  • Sockets - Metric

  • Complete Metric Socket Set

5.0 / 5.0
1 Review
5 Stars
4 Stars
3 Stars
2 Stars
1 Star
1
0
0
0
0
Tie Rods
These are an exact fit for my 2008 Dodge Magnum and work very well. They were so easy to install and the car drives so much better with no noise.
August 29, 2017
Purchased
11 months ago
Start typing your question and we'll check if it was already asked and answered. Learn More
No questions have been asked about this item. Be the first!

Vehicle Fit

  • 2005-2010 Chrysler 300 Rear Wheel Drive Front Outer Tie Rod Driver or Passenger Side
  • 2008-2010 Dodge Challenger Front Outer Tie Rod Driver or Passenger Side
  • 2006-2010 Dodge Charger Rear Wheel Drive Front Outer Tie Rod Driver or Passenger Side
  • 2000-2004 Dodge Dakota 2 Wheel Drive Front Outer Tie Rod Driver or Passenger Side
  • 2005-2010 Dodge Dakota Front Outer Tie Rod Driver or Passenger Side
  • 2000-2003 Dodge Durango 2 Wheel Drive Front Outer Tie Rod Driver or Passenger Side
  • 2005-2008 Dodge Magnum Rear Wheel Drive Front Outer Tie Rod Driver or Passenger Side
  • 2006-2009 Mitsubishi Raider Front Outer Tie Rod Driver or Passenger Side
  • 2011 Ram Dakota Front Outer Tie Rod Driver or Passenger Side

This part replaces:

  • OE # 52106710AC
  • OE # 52013468AC
  • Moog ES3571
Part #: 1ASTE00087

How-to Video:

(07:32 min)