Your sway bar helps your vehicle's suspension performance. The main purpose is to reduce body roll when going through a turn at speed. Although the sway bar itself is not a wearable item, the end links & frame bushings are.

Specifications:

  • REAR Sway Bar with Install Kit
  • Includes brackets, bushing, end links, & hardware
  • Replaces dealer part numbers: 10243923, 10274736
  • Direct replacement
  • Built to strict quality control standards

Lifetime Warranty

This item is backed by a Limited Lifetime Warranty. In the event this item should fail due to manufacturing defects during intended use, we will exchange the part free of charge (excludes shipping charges) for the original purchaser. Please keep your invoice for proof of this warranty.

  1. step : Removing the Wheel (0:38)
    • Remove the lug nut caps with a 19mm socket
    • Pull off the hub cap
    • Loosen the lug nuts with the vehicle on the ground
    • Raise the vehicle with a floor jack
    • Secure the vehicle on jack stands
    • Remove the lug nuts
    • Pull off the wheel
  2. step : Removing the Sway Bar Links (1:05)
    • Hold the upper sway bar link stud with a 14mm inch wrench
    • Remove the upper nut from the sway bar link with an 18mm socket and ratchet
    • Hold the lower sway bar link stud with a 14mm inch wrench
    • Remove the lower nut from the sway bar link with an 18mm socket and ratchet
    • Pull off the sway bar link
    • Remove the other sway bar link following these same steps
  3. step : Removing the Sway Bar (1:35)
    • Apply penetrating oil to the sway bar mount bolts
    • Remove the 15mm bolt from each sway bar mount
    • Lift the sway bar mount up and off
    • Slide the sway bar back and out
  4. step : Installing the New Sway Bar (2:26)
    • Put the new sway bar into place
    • Clip the sway bar mounts onto the sway bar
    • Put the sway bar links into place
    • Thread the nuts onto the sway bar links by hand
    • Push the sway bar into its mounts
    • Start the 15mm bolts into each sway bar mount by hand
    • Hold the upper sway bar link stud with a 14mm inch wrench
    • Fasten the upper nut onto the sway bar link with an 18mm socket and ratchet
    • Hold the lower sway bar link stud with a 14mm inch wrench
    • Fasten the lower nut onto the sway bar link with an 18mm socket and ratchet
    • Lower the vehicle onto jack stands so the suspension sits at ride height
    • Tighten the 15mm bolt into each sway bar mount
  5. step : Reattaching the Wheel (4:23)
    • Slide the wheel into place
    • Start the lug nuts by hand
    • Tighten the lug nuts preliminarily
    • Lower the vehicle to the ground
    • Tighten the lug nuts to 100 foot-pounds in a crossing or star pattern
    • Reattach the hub cap
    • Install the lug nut covers with a 19mm socket

Tools needed for replacement:

    General Tools

  • Floor Jack
  • Jack Stands

  • Materials, Fluids, and Supplies

  • Rust Penetrant

  • Ratchets & Related

  • Ratchet

  • Sockets - Metric

  • 18mm Socket
  • 19mm Socket
  • 15mm Socket

  • Wrenches - Metric

  • 14mm Wrench

There are no reviews for this item. Write Review
Start typing your question and we'll check if it was already asked and answered. Learn More
No questions have been asked about this item. Be the first!

Vehicle Fit

  • 2005-2009 Buick Allure Rear Sway Bar Kit for Models with RPO Code FE1 (Soft Ride Suspension) Dorman 927-110
  • 1997-2005 Buick Century Rear Sway Bar Kit Dorman 927-110
  • 2005-2009 Buick LaCrosse Rear Sway Bar Kit for Models with RPO Code FE1 (Soft Ride Suspension) Dorman 927-110
  • 1997-2004 Buick Regal Rear Sway Bar Kit Dorman 927-110
  • 2000-2011 Chevy Impala Rear Sway Bar Kit for Models with RPO Code FE1 (Soft Ride Suspension) Dorman 927-110
  • 2000-2011 Chevy Impala Rear Sway Bar Kit for Models with RPO Code FE2 (Ride Handling Suspension) Dorman 927-110
  • 2000-2007 Chevy Monte Carlo Rear Sway Bar Kit Dorman 927-110
  • 1998-2002 Olds Intrigue Rear Sway Bar Kit Dorman 927-110
  • 1997-2003 Pontiac Grand Prix Rear Sway Bar Kit Dorman 927-110
  • 2004-2008 Pontiac Grand Prix Rear Sway Bar Kit for Models with RPO Code FE2 (Ride Handling Suspension) Dorman 927-110
  • 2007-2008 Pontiac Grand Prix Rear Sway Bar Kit for Models with RPO Code FE1 (Soft Ride Suspension) Dorman 927-110

This part replaces:

  • OE # 10243923
  • OE # 10274736
  • Dorman 927-110
  • Hollander 524-00301
  • Hollander 524-00561
  • Hollander 524-00301, 524-00561
Only 2 left in stock
Part #: 1ASSL00360



Dorman
Brand #: 927-110

How-to Video:

(05:29 min)